Radiomaster Nexus • Flash F.Port with TX16s and Configure RotorFlight FPORT
Вставка
- Опубліковано 23 лип 2024
- F.PORT [FPORT] is a serial protocol with telemetry on a single wire. It is supported by RotorFlight and the Radiomaster Nexus.
In this video I'll show you:
1) How to flash an F.PORT [FPORT] receiver using a TX16s.
2) How to setup the Radiomaster Nexus with RotorFlight.
00:00 Intro
00:16 Build the Cable
00:45 Connect to Radio
00:59 Flash Firmware
01:42 Bind Receiver
03:02 Restore the Cable
03:47 Configure RotorFlight
RCVR LINKS
► Support the work I do here on Patreon: / rcvideoreviews
► RCVR MERCH rcvr.myspreadshop.com/
► Discord - Hang out with the RCVR Crew: / discord
AFFILIATE LINKS
► Amazon Affiliate: amzn.to/3lEz5ZL
► Banggood Affiliate: www.banggood.com/custlink/3DD...
#RCVideoReviews #rotorflight - Наука та технологія
John, Thank you!
You are welcome!
how did you figure out the needed CLI lines? i was stuck trying to get it to work with the rx on fport until i saw your video... thanks!
I appreciate the video but made the jump to ELRS with the FlyDragon F722 (competes with the RM Nexus). Getting rid of the external satellite of any kind was a nice bonus for me. Rangers aren't that expensive either. I'm sure a future Nexus will have internal ELRS like the FlyDragon already does.
I was a little surprised they released the Nexus sans internal ELRS, but I guess it leaves the door open to all RF tech without incurring the extra $20 cost. I kinda hope they release an all-in-one too.
Just bought a Boxer with EdgeTX. Upgrading from Taranis X9D OpenTX. Is your video on converting by going back to Edge 2.8 to convert still valid? Thanks
Yes. You can no longer go from OpenTX to the latest version of EdgeTX without stopping on 2.8 first. After 2.8, EdgeTX no longer reads and converts binary files to YML format. ua-cam.com/video/NYbOLLoV-GA/v-deo.html
@@RCVideoReviews Thanks, but this does not work on a Boxer. I cannot flash the 2.8.4 firmware by pressing the jog wheel, nothing happens. My new Boxer was shipped with Edge 2.9. My old TX is a Taranis X9+ and I'm hoping to shift my models setup from the Taranis to the Boxer then flash the Boxer with the latest Edge. Any clues? Thanks
Obviously, this does not apply to ELRS? Right?
No. ELRS is 2 wire full duplex and a different protocol.