I had a similar situation just yesterday. A customer came in with crank and no start with 2002 pathfinder. I check for codes first before digging around and found a p0160 I think something about lock mode. I just had to replaced the immu that sits next to the ignition key and performed a c/u initialization then the car started right up. Btw you are true technician with your set up.
Thanks for the good diagnostics video.... I'm always wanting to know more about this pathfinder I have. I do most of my own repairs, and plan to stay with this model for awhile.
Great descriptive video brother. Got same issue on my 02-driving along fine and it just died. Have eliminated feul circuit already and will try your diognostic/fix and see if I have the same issue. As other commentors have had same issue, I'm hoping this is MY problem too. Cheers!!
I'm still not getting what you did, bro. You" connected directly to the relay, thru a ten amp fuse, you reconnected the coils then cranked the engine and it ran. Battery voltage power already runs thru a ten amp fuse to a relay. The fuse is labeled eccs1. You "direct connecting" , doesn't mean squat, other than you plugged a lead into the bottom side of the fuse panel, to where that fuse would sit,
That leads to be rely. It's the same configuration, just connected outside of that fuse panel. Oh and, yea the vehicle starts... You put it in Drive, and it blows the fuse!
I had a blown ECCS2 fuse and it wasn't starting (2003 Pathfinder). I replaced the fuse, and it does start now. However... It will not stay running unless I feed it gas; It will not idle on it's own. Any suggestions on where to start looking?
@@nelsonjuniornoizy5320 it ended up being the ECM. I bought the correct resistor and soldered it in. The idle was still high afterwards but I borrowed the old Nissan scan tool from work and it forced it to reset the idle.
I got a 1999 nissan pathfinder crank no start check the fuel system is fine but it would start run perfectly for 30 seconds an stall out an won't start but will turn over any idea people told me it could be the distributor or the crank shaft sensor any thoughts would be appreciated
Thanks for the good diagnostics video.... I have an 2003 pathfinder that won't start easily and the engine stall while driving. what do you suggest me?
Have your car checked by a computer .. or if that’s expensive for you, try to check the resistance on your crankshaft sensor “ look out the video “ how to check crankshaft sensor “ on UA-cam.
@@reginaldpierre6490 then check the other plugs that are connected to the engine, if all of them are good! Check your air filter sensor. To be sure check the relay fuse on the electronic box. The white one. It should be written on it.
hola,tenemos una nissan pathfinder 2001, no le podemos apagar la luz de servicio, se le cambio el censor iac por los codigos 550 505,me puden alludar con algun a recomendacion
Hey anyone can tell me what I can do to fix my problem with my 2006 pathfinder it crank but won't start and all the lights stay on my dashboard even after removing the key close all doors and the only way the lights will turn off is unplugging the battery
I had a similar situation just yesterday. A customer came in with crank and no start with 2002 pathfinder. I check for codes first before digging around and found a p0160 I think something about lock mode. I just had to replaced the immu that sits next to the ignition key and performed a c/u initialization then the car started right up. Btw you are true technician with your set up.
Thank you so much I'm having this very same issue with my 2002 Qx4
Superb diagnostics sir,well fone steve from the uk
Thanks for the good diagnostics video.... I'm always wanting to know more about this pathfinder I have. I do most of my own repairs, and plan to stay with this model for awhile.
Great descriptive video brother.
Got same issue on my 02-driving along fine and it just died. Have eliminated feul circuit already and will try your diognostic/fix and see if I have the same issue. As other commentors have had same issue, I'm hoping this is MY problem too. Cheers!!
I'm sitting on the side of the hwy with this exact issue... just derated and now dead
I'm still not getting what you did, bro. You" connected directly to the relay, thru a ten amp fuse, you reconnected the coils then cranked the engine and it ran. Battery voltage power already runs thru a ten amp fuse to a relay. The fuse is labeled eccs1. You "direct connecting" , doesn't mean squat, other than you plugged a lead into the bottom side of the fuse panel, to where that fuse would sit,
Placed an inlinedned fuse between Batter power,
That leads to be rely. It's the same configuration, just connected outside of that fuse panel. Oh and, yea the vehicle starts... You put it in Drive, and it blows the fuse!
I had a blown ECCS2 fuse and it wasn't starting (2003 Pathfinder). I replaced the fuse, and it does start now. However... It will not stay running unless I feed it gas; It will not idle on it's own. Any suggestions on where to start looking?
Check the spark plugs, coils because the same issue happened to me last month and I replaced the coils and now everything works great
@@nelsonjuniornoizy5320 it ended up being the ECM. I bought the correct resistor and soldered it in. The idle was still high afterwards but I borrowed the old Nissan scan tool from work and it forced it to reset the idle.
I got a 1999 nissan pathfinder crank no start check the fuel system is fine but it would start run perfectly for 30 seconds an stall out an won't start but will turn over any idea people told me it could be the distributor or the crank shaft sensor any thoughts would be appreciated
Relays
Thanks for the good diagnostics video.... I have an 2003 pathfinder that won't start easily and the engine stall while driving. what do you suggest me?
Have your car checked by a computer .. or if that’s expensive for you, try to check the resistance on your crankshaft sensor “ look out the video “ how to check crankshaft sensor “ on UA-cam.
I already done it, everything is OK
@@reginaldpierre6490 then check the other plugs that are connected to the engine, if all of them are good! Check your air filter sensor. To be sure check the relay fuse on the electronic box. The white one. It should be written on it.
hola,tenemos una nissan pathfinder 2001, no le podemos apagar la luz de servicio, se le cambio el censor iac por los codigos 550 505,me puden alludar con algun a recomendacion
Definitely a good video.
What were the codes?
Thanks homie
Hell Jess how are you I have a problem with my nissan pathfinder can you help me please
Got same issue on my 2001 qx4 but it start after 2 times of crank .... it is like that for 2 years and I gave up
I have the sem problem coud you help me
Hey anyone can tell me what I can do to fix my problem with my 2006 pathfinder it crank but won't start and all the lights stay on my dashboard even after removing the key close all doors and the only way the lights will turn off is unplugging the battery
Iam having same exact problem!!!
Helo mine has no engine light and no crank no start
hello friends a question what was the problem the relay..or the coils? .. my car is the same as it is
I have a 3.5 and the car Nissan not firing dont have gas
I have no crank. What can it be?
Immobilizer.