Generator Synchronization Problem, Load sharing Fault 4 Generator System 600VAC of Jack-up Barge

Generator Synchronization Problem, Load sharing Fault 4 Generator System Load Sharing for 3 Legs Jacking System, Jack-up Barge

[@somethingsomeone5440]

What’s the normal fuel consumption of those big cat generators? Imagine it’s quite a bit

[@neu-s]

Please I have a problem with our vessel emergency generator on harbor mode.
When on emergency mode , it run ok.
But when switch to harbor mode, it drop in frequency while running and the vessel will go into blackout and the generator will gain back rated rpm/Hz

[@Wallace.w]

Hello, I have deif can't read god current, nor tension and nor parameters. So coupling with the device is impossible. If you have an idea for solve this problem. Thanks before!

[@Lauritzbirch]

Deep sea gave us a challenge. 3weichais and 3 mtu. Total about 8mva. Can't sync to transformers. Firmware issues I think.

[@TalhaAbid-e7m]

❤

[@QuansahBryce]

please i have a problem with my comap the synchroscope keeps spinning which is not allowing the synchronization to activate

[@vichusvichu2779]

Hii Sir I have problem in marine Caterpullar Generator while load sharing I can"t change one Generator to other

[@rajasthanchhotikhatu1452]

Hello chief i have DG 2 IS 7535 ANY DG MISSING ERROR IS COME PLEASE help me how to solve this error please

[@ibtech010engribrahim9]

Good day pls I have 3generator one grid pls advice what type of module can I use to control the three generator for load sharing tnks

[@bajmarineequipmentrepair]

Hi Chief, Mostly we're using Woodward Modules, just send your requirements to them and then they will give you options

[@Basnak]

ComAp inteliGen, inteliLite,... now they make very good and nice controlers

[@dinguskitchen8996]

Deif AGC 150

[@saketsachar5355]

how can i contact you

[@bajmarineequipmentrepair]

You can send email on my email address.

[@saketsachar5355]

@@bajmarineequipmentrepair thanks, mail sent

[@saketsachar5355]

hi, have not seen your reply.

[@ibtech010engribrahim9]

Pls reply me

[@raw_lee77]

Bruce ikaw ba yan…

[@bajmarineequipmentrepair]

Yap, please help to share and subscribe please. Thanks in advance.

[@arpitdas3499]

Vogus