Hello, thanks for the information and for got AT2612D with fault: mid 130 psid 232 fmi 9 I checked all can wires were ok, then customer brought another used trans to replace it, I am checking it on bench out the truck with special harness and still I am getting same fault on the 2nd transmission. Please help is appreciated
Do you usually get a cod for this part if dose goes out ? My 2015 vnl drives good forward , but got a crazy jerking when going revers loaded and slightly hill. Can t go reverse at this point.No codes detected.
Not always. Does it feel like its jumping out of gear? Does it also do it in 1st forward if it does you have a internal transmission problem. I'm in Sacramento I can be contacted at Volvobtms@gamil.com
@@volvobigtrucks8640 no , it makes this problem only in revers ,(but sometime in in 1st rpm gose to hi -close to red , before going in next gear ). Some online topics with same reverse jerking have told that the diagnostic from repair shop came as bad clutch /pressure plate clutch.. but never came back to let us know if it fixed the problem. Is it posible to be the only issue at 610xxxx miles?
@@tinashemutuma315 yes . But it wasn t this part . All the clutch assembly had to be replaced , visually it was easy to tell is time for new one. The shop put it back , problem was still present. Had to be dragged down again and send it for complete rebuild.. had some gears and bearings replaced inside. After rebuild start working fine again . Cost me 12000 for all that ,rebuild plus shop.
Awasome video, thank you for sharing your knowledge.
How do you know if it failing where should I hear air leak on this?? Is air leak internal?? Do I need to calibrate it after changing ??
Hello Thank you for this demonstration, I would like to know you bought this test cables or you built this cable which connects ?
Thanks
Thank you bro
Bro My truck model 2003 automatic truck start 2 hours gair shift sounds why please reply
Hello, thanks for the information and for got AT2612D with fault:
mid 130 psid 232 fmi 9
I checked all can wires were ok, then customer brought another used trans to replace it, I am checking it on bench out the truck with special harness and still I am getting same fault on the 2nd transmission. Please help is appreciated
Thanks for you they help me a lot
Do the whole thing have to come off to add the quick disconnect for the airline
Thank you 👍👍👍
Does the transmission need to be removed to replace this part? And does this part need to be recalibrated with computer?
you dont need to pull the trans to replace it, its outside on passenger side.
calibrating is a good idea but not mandatory
@@drey-4893 thank you brother 🙏
Thank you again bro
What kind of symptoms do you get when this valve is on its way out?
Air leak
Especially when you press the clutch
@@kamtarbol there is no clutch to press in volvo ishift.
@@jrtruckltd you have a i shift with clutch as well.
@@jrtruckltdthe brake is the clutch on ishift…
Sir,
Does this could cause fault “mid130 psis27 fmi8”
Thankyou
yes it can but there release cylinder and hose can cause it.
Thanks man good info
Where is your shop?
Thank you helpful
how to coil supply voltage
Are these transmissions reliable or not?
Ours give us a lot of headaches we have Volvo Vnr 2019
Very nice
Do you usually get a cod for this part if dose goes out ? My 2015 vnl drives good forward , but got a crazy jerking when going revers loaded and slightly hill. Can t go reverse at this point.No codes detected.
Not always. Does it feel like its jumping out of gear? Does it also do it in 1st forward if it does you have a internal transmission problem. I'm in Sacramento
I can be contacted at Volvobtms@gamil.com
@@volvobigtrucks8640 no , it makes this problem only in revers ,(but sometime in in 1st rpm gose to hi -close to red , before going in next gear ). Some online topics with same reverse jerking have told that the diagnostic from repair shop came as bad clutch /pressure plate clutch.. but never came back to let us know if it fixed the problem. Is it posible to be the only issue at 610xxxx miles?
@@eugeniujosanu279 did you manage to fix ?if so what was the problem
@@tinashemutuma315 yes . But it wasn t this part . All the clutch assembly had to be replaced , visually it was easy to tell is time for new one. The shop put it back , problem was still present. Had to be dragged down again and send it for complete rebuild.. had some gears and bearings replaced inside. After rebuild start working fine again . Cost me 12000 for all that ,rebuild plus shop.
@@eugeniujosanu279 i had the same problem, my transmission also had to be rebuilt
Hello. Where are you located? Need you service
@@volvobigtrucks8640 page don't work
Sar kam mil sakta hai
WHAT KIND PROBLEM YOU GET WITH THIS
Зачем взял и разломал всё
Только дебилы такой печатают
Hello Sir, we are producing this valve in Taiwan. Are you interested to buy our product?
Do you have contact information? How much does it cost?
Yes i want to buy......
I buy them...!
I got one original for sale, any one interested?
I have one original one, any one interested ?!
Hello I am interested
I am still have bro
@@venitiacasa call me if you want it
How much?