Saw your video en my launch break at work. You made all the build very interesting. The time sliped off. I enjoyed mysellf and liked the way you resolve things. Greetings from Argentina.
Hi from the USA, thank you for your interest and your comments, you are my first subscriber from Argentina. So thank you for letting me know where you are from. I am glad you like our videos . Joe H
Thank you for your comment Robert. Knowing what others think helps us to understand better what we should make videos of and what we should show. Thanks again , Joe.
Hi Kelly, I use drill rod for the shaft and crank pin . For the web it makes no difference. That one was 12L14 because I had it, but hot roll or any cold rolled is fine.
If I may suggest...? holding round thing in a vice (the way you do it st 5:00) is asking for trouble If your vice opens wide enough? I would use vee block on fixed jaw side to give you three point location Probably not serious issue for just drilling a hole, but.... 👍 subscribed to see more
Thank you for your comment. I usually use that method if I’m taking a serious cut or a cut when the cutting will be likely to turn the part. But you have a good point, I should not use short cuts on the videos. It looks bad. Joe
Saw your video en my launch break at work. You made all the build very interesting. The time sliped off. I enjoyed mysellf and liked the way you resolve things.
Greetings from Argentina.
Hi from the USA, thank you for your interest and your comments, you are my first subscriber from Argentina. So thank you for letting me know where you are from. I am glad you like our videos . Joe H
Good distortion control there mate 👍
Regards
Robert
Thank you for your comment Robert. Knowing what others think helps us to understand better what we should make videos of and what we should show. Thanks again , Joe.
Great content Mr Higgins thank you
Hi Nigel , I appreciate and look forward to your comments.thank you very much Joe
Great content again! What material are you using to build up your crankshafts?
Hi Kelly, I use drill rod for the shaft and crank pin . For the web it makes no difference. That one was 12L14 because I had it, but hot roll or any cold rolled is fine.
If I may suggest...?
holding round thing in a vice (the way you do it st 5:00) is asking for trouble
If your vice opens wide enough? I would use vee block on fixed jaw side
to give you three point location
Probably not serious issue for just drilling a hole, but.... 👍
subscribed to see more
Thank you for your comment. I usually use that method if I’m taking a serious cut or a cut when the cutting will be likely to turn the part. But you have a good point, I should not use short cuts on the videos. It looks bad. Joe