you need a special spring compression jig to install springs and this guy installed roller bearings backwards...do not do it like this video or you will have a ruined head
@@tonymills9402 this is hard part ! its either a tool (like Laser 7120) or a small bar between spring coils, 2 13 or 14mm spanners and a small piece of aluminum behind spanners between coils, and push back. be VERYT careful when winding down the torx bolt (either E6 or8, can't remember), as it is so easy to cross/strip thread (have done this myself :( ). very silly design in my opinion.
@@AJ-yx7wt or Watch "BMW Mini Peugeot 207 head gasket cam fitment part 1" on UA-cam ua-cam.com/video/8mvGFad65zY/v-deo.html I honestly found this worked a treat! Simple and effective The cam lifts away with the springs as a complete assembly, no need to release the tension and no need to reinstall (risking cross threading).
Te felicito desde Puerto Rico no sabes cuánto me has alludado
Love this video slow and with detail 😊
you need a special spring compression jig to install springs and this guy installed roller bearings backwards...do not do it like this video or you will have a ruined head
Mantap videonya pak sukses terus.
Would also love to know the torque spec also.
It would have been nice to see how you got the valve springs back in the correct location. I did not see in the video how it was done.
looked up torque spec and for the N12 engine it shows 10nm for both intake and exhaust cam caps.
how do you install the intermediate shaft properly?
if not because the spring broken, i don't need to remove those bolts to do valve seals or do the head job !
What is the torque specs
ЖЭСТАЧАЙШЭ.
So it is possible to rebuild head on Prince engines?
where can i buy the tools for N18?
Was hoping to see how you put the springs back, waste of time
I know, how did he get the springs back behind the intermediate rockers
@@tonymills9402 this is hard part ! its either a tool (like Laser 7120) or a small bar between spring coils, 2 13 or 14mm spanners and a small piece of aluminum behind spanners between coils, and push back. be VERYT careful when winding down the torx bolt (either E6 or8, can't remember), as it is so easy to cross/strip thread (have done this myself :( ). very silly design in my opinion.
@@AJ-yx7wt or Watch "BMW Mini Peugeot 207 head gasket cam fitment part 1" on UA-cam
ua-cam.com/video/8mvGFad65zY/v-deo.html
I honestly found this worked a treat!
Simple and effective
The cam lifts away with the springs as a complete assembly, no need to release the tension and no need to reinstall (risking cross threading).
Useless vid. Not a single torque spec.
Совсем не понятное видео. Нужно рассказывать, по вашему видео можно по разному воспринять действительное
Don't like didn't tell me torque specs