Propel Endeavor PRO Lighting

This is Don from DRC Dons Riding channel and here is a video for the lighting on my new Propel Endeavor PRO. I use Shred Lights on my boards because I can move them from board to board and I use one for my helmet for the night rides. I fabricated the rear bracket for the tail light / Go Pro mount. I made a cardboard template of the light bracket that fits front or rear lighting. It works great!

[@jeffreybenson8910]

Couldn't figure out why they included front motor mounts. I removed mine, but good idea.

[@miked250]

Did you drill the shred mount hole bigger? I bought a 5/16 bolt and it doesn't fit through.!

[@DRCProductions]

Yes I did.

[@miked250]

@@DRCProductions Thanks

[@iimaginedesign4217]

Where did you get the middle plate that connects between the ShredLight 45 degree mount and the board.

[@DRCProductions]

It is a shred light 45degree light bracket. Super cheap and works great. You can tilt it up or down depending on where you want to point the light.

[@caseycollins7294]

Can you post a link to what you purchased?

[@iimaginedesign4217]

Apparently the Endeavor one came with these plates as part of the old light set up. Propel doesn’t advertise on their site anymore since they have a new version of front lights but you can still email them and they will sell it to you $19 each and they will fit the Endeavor 2. Once you have these plates then you can buy the 45 angle plates from shred lights to attach.