Bob Smith Industires Insta-Set Accelerator and UN-CURE by ModelMerchants.com

We explain how to properly use Bob Smith Industries' Insta-Set Accelerator (BSI151/BSI152) when using it with Cyanoacrylate CA glue and removing any accidental/excess applications of CA glue by using UN-CURE (BSI161), a Cyanoacrylate debonder.
Visit us online at www.modelmercha...
Buy INSTA-SET Accelerator: www.modelmerch...
Buy Bob Smith UN-CURE: www.modelmerch...
Please leave your questions/comments in the comment section below and thanks for watching.
Bob Smith Industries Insta-Set Accelerator (BSI151/152): INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead of thick CA along a seam and then curing it with INSTA-SET™ significantly enhances a joint’s strength. For difficult to bond materials, INSTA-SET™ can be applied to one surface and CA to the opposite surface. When brought together, they will bond instantly. INSTA-SET™ is formulated with a strawberry scent and activates CA in 6 to 8 seconds without any degrading of the CAs strength, which can occur with many other accelerators. It is compatible with all surfaces, even clear plastic and white foam.
Bob Smith Industries UN-CURE: UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute. Apply on bonded skin and roll apart fingers. Once stuck, use acetone to clean off softened CA, then wash off with soap and water. Since cured CA is essentially acrylic plastic, anything that will dissolve CA will also soften most plastics. Care must be used, therefore, when using Un-Cure on plastics. Separating plastics parts with a razor saw is usually the best option.

[@slappy2825]

Cyanoacrylate accelerators can lead to a stronger final bond, not a weaker bond. This is especially so in dry climates and between difficult substrates that contain a lot of oil or acid (e.g. wood). Cyanoacrylate uses moisture in the air to cure. It is a highly reactive adhesive. Once it begins to cure, it forms a permanent bond with the substrate. A super glue accelerator helps provide moisture to speed up the curing process and it can help in dry very environments.

[@DeyvidMMO]

When using the InstaSet, would glue penetration into the material be a concern if you are joining two 3D printed (PLA) pieces together?

[@devildawg4947]

Is the insta set reef safe?

[@rodrigoroa17]

I bought the 20 minutes. I do not like it, it takes more than 60 mitutos or it left last and it stops almost water, it drains everything, how to get my money. where I send it

[@szs114]

The Debounder is useless. I bought it, and don’t know where to throw this stuff.

[@timothythomas1345]

aRE THESE GLUES SIMILAR TO TECH BOND Brand glues . And if so are they cheaper . I am a glue geek SO TO SAY AND i LIKE TO KEEP VARIOUS GLUES AND EPOXIES ON HAND AS WELL AS TAPES FOR WHAT EVER MAY COME ALONG . aND JUST HEARD ABOUT TECH BOND

[@modelmerchants331]

Since we have never used Tech Bond, we cannot comment in regards to how they compare with one another.

[@vidskitkid]

An informative and useful video but as a very visually oriented guy I could not help to be continuously distracted by the poor focus of the video showing tight shots of your products. Too bad!