AW11 Chassis Harness Work for Stand Alone Use

Connector diagrams and additional info at www.kswapmr2.com under the AW11 Wiring. This video will be followed by another video on PNP relay board creation.
This video details the work to create a plug-n-play patch harness to simplify engine swaps and ecu conversion.
12 pin molex
1 . tach
2. fuel pump
3. ignition on
4.reverse lights
5. cel
6. starter signal
7. ground
8. alternator light
9. oil pressure gauge
10. Speed signal
11. water temp stock dash
12. a.c. compressor clutch

[@timbarrett5166]

Appreciate all you do for the MR2 community. Sell the product to those who want to buy it, teach it to the people who want to learn it. Keep on doing what your doing

[@HuxRacing]

I figure if I document the info I will know were to find it.....lol

[@trevorcannavo]

I can't thank you enough for this tutorial. Did you ever make an AW11 "PNP relay board creation" tutorial video?

[@saik0uguy]

Incredibly informative, many thanks again Eric !

[@HuxRacing]

You are more than welcome

[@saik0uguy]

@@HuxRacing are the M1 and M2 plugs still sourceble? I've stupidly sold my engine with the harness ages ago otherwise I will have to cut the ends of and replace it with a different connector

[@HuxRacing]

I would highly doubt you can buy them new. Lots of old aww1 harness out there though.