[DIY] Can the adjustable grooving cutter can be used with a Makita table saw?

This video verifies whether a adjustable grooving cutter can be used with a Makita table saw.
As stated in the instruction manual for the Makita 2703 circular saw board, a grooving cutter is sold as an optional part, so a single-width cutter can be used.
This time I will try Dainisho's adjustable grooving cutter AJ-120G, which allows you to freely change the groove width between 3mm and 15mm by adjusting the dial in the center of the cutter.
Some of them could be changed from 3mm to 21mm, but there was a possibility that they couldn't be used, so I bought an inexpensive one this time.
However, I thought that it would not be usable as it is, so I have purchased some optional parts for attaching the groove cutter.
I bought a ring, a flat washer, an outer flange, and a hex nut.
A flat washer was not required to use a 3mm to 15mm free grooving cutter.
As for the insert, I had to make it for it, but I was able to use it safely.
As for the impression I saw using it, it has a good sharpness and can be easily grooved, so I think it is useful for grooving to fit the bottom plate of the drawer.
It is easier and less error-prone than using a trimmer, and you can freely handle the thickness of the bottom plate.
This product is recommended.
--------------------------------------------------------------------
--　Dainisho adjustable grooving cutter AJ-120G
--------------------------------------------------------------------
www.amazon.co....
--------------------------------------------------------------------
-- [DIY] Makita 2703 table saw review (SK11 STS-255ET table) Compare with table saw)
--------------------------------------------------------------------
• 【DIY】makita2703 丸ノコ盤レビ...
--------------------------------------------------------------------
-- [DIY] Makita 2703 Preparation before use of table saw (Zero clearance insert production)
--------------------------------------------------------------------
• 【DIY】Makita2703テーブルソーの...
The tool used this time
・ Makita 2703 Table saw
・ Dainisho Adjustable Grooving Cutter AJ-120G
・ Makita Rechargeable Impact Driver TD110DZ 10.8V
・ Automatic planer hard head No.21722S
・ RYOBI HL-6A Hand-held planer
#diy
#garage
#tablesaw
#Groovingtools

[@gentadiy]

たいへん参考になりました。
電動丸のこでこの自在切りカッターを使えないか動画お願いします。

[@ZUBUGARAGE]

チップソーのカバーが干渉しそうですが、何かの時に試してみます

[@user-mv3de3zi4y]

5mm幅のCUTは綺麗にCUT出来ますか？
出来れば5mm幅CUTの映像を見せて頂きたいです、
よろしくお願いします。

[@ZUBUGARAGE]

こんにちは、3mm～15mmの間なら幅は自在に変えられますよ。
但しノッチがある訳ではないので端材で試してから本番加工すると良いと思います。
取付時に動いてしまいますから。

[@user-mv3de3zi4y]

返事ありがとうございます、マキタの三面仕上げカッター(A-22610 4.5mm巾は使ったことありますか？

[@ZUBUGARAGE]

残念ながら使った事はありません、使って見たいですけどね。

[@larissa5083]

p̷r̷o̷m̷o̷s̷m̷