Thanks, this is the best controller swap guide I’ve found on UA-cam! There is just one point you could add - the reason the controller is hard to remove is because there are two plastic clips holding it down. You can pry these apart using a flathead screwdriver, then it becomes easy to remove and you don’t need to bother unscrewing the bottom 😊
Hi, I installed the 32km controller on my ninebot f2 pro, everything works except the rear brake light, I checked the controller several times, all the wires are installed correctly, before installing the new controller the light worked, what could be the problem?
Hi. Use a multimeter to check for voltage output to the brake light when the brake lever is pressed. If there is no output, the issue might be within the controller. The other option would be to install old controller to ensure that rear brake light is still working and problem is in a new controller. You can also reach out to Segway support or a professional repair service. They may provide further troubleshooting tips or arrange for repairs.
@@alexmateiafrasinei8283 u need to buy st-link little usb with cables then take the stock controller out solder some wires to the st-link flash xiao dash and done
Thanks, this is the best controller swap guide I’ve found on UA-cam! There is just one point you could add - the reason the controller is hard to remove is because there are two plastic clips holding it down. You can pry these apart using a flathead screwdriver, then it becomes easy to remove and you don’t need to bother unscrewing the bottom 😊
Thank you for sharing your experience 👍I’m glad to learn this method 😸Wishing you both lots of luck ❤❤
Thanks for this video. It’s both enjoyable and illuminating !
Nice video, entertaining and instructive, thank you!
good idea … thanks a lot … liked to watch it 😊
👍👍👍💯
Hi, I installed the 32km controller on my ninebot f2 pro, everything works except the rear brake light, I checked the controller several times, all the wires are installed correctly, before installing the new controller the light worked, what could be the problem?
Hi.
Use a multimeter to check for voltage output to the brake light when the brake lever is pressed. If there is no output, the issue might be within the controller. The other option would be to install old controller to ensure that rear brake light is still working and problem is in a new controller.
You can also reach out to Segway support or a professional repair service. They may provide further troubleshooting tips or arrange for repairs.
Okk grazie
Pls make slow tutorial pls❤❤❤
xiaodash ( 39 euros ) Stage 3 , débridé a 50 kilometreur (no limite ) j'ai modifier le frein avant.
hast du geschaft f 2 pro zum entsperen? kannst du mir helfen ich zahlen dir wenn es moglich ist .. danke
@@alexmateiafrasinei8283 u need to buy st-link little usb with cables then take the stock controller out solder some wires to the st-link flash xiao dash and done
How much did you pay for the controller?
about $35
There are a lot of sellers in aliexpress with different prices.
2r93🎉
or just connect ST-LINK to the controller and install new firmware and boom 40km/h at flat road
Have you tried such solution? Where did you get the firmware?
You tried xdash on the Controller? Does it Work?
@@2bIackyeah works fine i have xiaodash but SHU (scooter hacking utility probably better (its free)
What is the program? How do I increase the speed to 40 kilometers?
@@heshams774 u need some skills do do that because u need to take out the controller and solder some wires on it