Hello Fred! Just want to check if you have any input for me. :-) I recently bought a .22 K1 and it developed a severe regulator creep. The problem was some small plastic debris from the edge of the valve seat in between the valveseat and sealing o-ring so it was an easy fix. I did how ever notice that the #88 o-ring on the valve stem was missing, only the #91 seal ring was present and the gun had no other leaks but I still replaced it when assembling the regulator and it has been working fine for a couple if months until now. The gun have been sitting for about two weeks at 200bar and when I went and filled it up to 350bar it did the creep again. This time it was the previously missing o-ring that had stuck to the valvestem thus helping the spring open the valve when the pressure was rising so it was another easy fix but I still wonder if it would be wise to remove the o-ring and only run with the hard seal ring? Or is the problem my Biltema Silicone grease? This time I used a liberal amount of the silicone grease provided with the Eagle vision cam fill probe I got for my P15 so we will see if it holds up any differently. Is there any special make of lubricant you can recommend? Best regards
Thank you so much, for your job and help. God bless you!
虎贲的设计者绝对是把QE阀玩明白了，无论是这个调节器还有发设阀都是QE阀的原理，调节阀加了调节压力和手动开闭，发射阀就是QE原理，这么设计就是为了适应高压和申请专利卖钱😀
Nice job thanks for sharing
Hello Fred!
Just want to check if you have any input for me. :-) I recently bought a .22 K1 and it developed a severe regulator creep. The problem was some small plastic debris from the edge of the valve seat in between the valveseat and sealing o-ring so it was an easy fix. I did how ever notice that the #88 o-ring on the valve stem was missing, only the #91 seal ring was present and the gun had no other leaks but I still replaced it when assembling the regulator and it has been working fine for a couple if months until now. The gun have been sitting for about two weeks at 200bar and when I went and filled it up to 350bar it did the creep again. This time it was the previously missing o-ring that had stuck to the valvestem thus helping the spring open the valve when the pressure was rising so it was another easy fix but I still wonder if it would be wise to remove the o-ring and only run with the hard seal ring? Or is the problem my Biltema Silicone grease? This time I used a liberal amount of the silicone grease provided with the Eagle vision cam fill probe I got for my P15 so we will see if it holds up any differently. Is there any special make of lubricant you can recommend?
Best regards
I'm from China. Thank you so much for the video. Can you buy me this huben k1 valve? I pay you the reward
Buy the Huma regulator.
Saya kepingin bisa buat sendiri mohon bimbinganya n diagram/skema ukurannya bisakah 🙏
Tiger spray k12/3 3D process drawings
How i buy the k1
I am malaysia
有卖吗？
顶你个肺 You can contact the retailor in your region.
@@fredli3661TM翻墙想诈骗老外？
Surly polishing is way better than filling with grease?