Thanks for the video. Have the same PSU for a HP Microserver N40L... it's dead. The chip you replaced seems good on mine (0.5V on the diode test). There's also 340V across the bulk cap so I think the HV primary is ok. None of the transistors appear to be shorted. The DC outputs aren't shorted either. I haven't figured out what is wrong with it. Btw, is the green wire the power good signal? Doesl jumping it to ground turn on the PSU?
This power supply (Delta DPS-150TB) is used in a HP ProLiant MicroServer N40L. These MicroServers are used as a home/office NAS. The power supply in my server has just failed. So it might be a similar fix to get mine going again.
My power supply was also damaged. IC901(TNY268P) seems to be fine, but I will replace it to be sure. In my case, the R902 resistor was damaged (burned). Does anyone know what resistance it should have? I couldn't find a schematic for this particular power supply.
Always wait for your excellent troubleshooting for PSU.
Thanks
Thank you for your support.
I will record some videos soon.
Такой же блок, не понятно что проверять на этом чипе, прозванивалку?
@@просто-в2с именно её)
Thanks for the video. Have the same PSU for a HP Microserver N40L... it's dead. The chip you replaced seems good on mine (0.5V on the diode test). There's also 340V across the bulk cap so I think the HV primary is ok. None of the transistors appear to be shorted. The DC outputs aren't shorted either. I haven't figured out what is wrong with it. Btw, is the green wire the power good signal? Doesl jumping it to ground turn on the PSU?
@@orlypalomar green wire is PS on wire. Jumping it to the ground should turn on the PS. If not check capacitors. They may be the reason.
This power supply (Delta DPS-150TB) is used in a HP ProLiant MicroServer N40L. These MicroServers are used as a home/office NAS.
The power supply in my server has just failed. So it might be a similar fix to get mine going again.
My power supply was also damaged.
IC901(TNY268P) seems to be fine, but I will replace it to be sure.
In my case, the R902 resistor was damaged (burned). Does anyone know what resistance it should have?
I couldn't find a schematic for this particular power supply.