Це відео не доступне.
Перепрошуємо.
How to Change Mustang Axle Halfshaft EASIEST AND FASTEST WAY
Вставка
- Опубліковано 8 лис 2020
- Please Subscribe and Thanks for watching! Hope this helps. You need a 32mm, 21mm 18mm and 15mm sockets, a pry bar, maybe a breaker bar, and a friend.
Below is how we broke it!
• We broke 3 Mustangs an...
2 years later and this video is still helping people. I just upgraded to gt350 axles and your video was spot on. Worked amazing and was able to geterdone fast. I did disconnect the brake line bracket from the sway bar end link just to give me a few more inches of lift, but not totally necassary.
What’s up bro sorry to bother you
Where did you buy your axle shaft upgrade kit, I’ve seen the one on steeda but don’t know if it’s the correct one
Thanks for the tips. Very efficient and effective way of getting this job done
just came across this video and honestly a life savor saved lots of time
thanks alot
I have boots leaking on my 2004 cobra. Getting ready to replace them. Glad I found this.
Very helpful content!
thanks for the video mississippi boys yall showed me enough that i think i can fix my 01 svt cobras IRS. I believe im having the same issue. thanks for the info
Shout out Mississippi👌
Thank you for the content I just broke one of mine and it’s the ford performance one and now I understand why and can change myself now. I appreciate this video
Sorry to hear that, I know it sucks lol but you'll have it right in no time
How did the install go?
Fun stuff
Clutch, gotta do mine on my 2016. Stock axles and 16psi oof
where can u get the gt350 axles for $150???
Honestly I think I’d rather the half shaft be the week link if they’re this “easy” (relatively speaking compared to other parts) to change.
Doesn't look like the Ford garage would be able to charge a lot of hours worth of Labor to do a axle swap then nicely done guys
Should’ve place a jack stand under the lower control are to simulate a load on suspension. The bushings only rotate very limited motion.the suspension will now be off in the rear when launching causing a left or right deflection. Good luck holding it straight.
You know what, you're right lol. What would be your recommendation to get it back correct? I've had some squeaks and on a hard launch it does pull some.
@@R3VIVALGT with the wheels off. Loosen all the bolts on the pivot points with a floor jack under the lower control arms, then retorq the bolts, all set. The jack simulates the suspension under load .
Should’ve added. Do not loosen the inner upper control arm or the inner lower tow link. Basically every thing you had removed
@@MustangGuru thanks, I put jackstands under the springs on each side, loosened and retorqued those 3 bolts and I no longer have the butt wiggle
Just seen you driving and seen the UA-cam channel sticker
Yo lemme get a sub 😂
did you need an alignment after that?
Just saw this, I did not
My half shaft is not this easy. Its stuck in there. Should I put my car in neutral to make it easier? Anyone with some information?
Did u get it fixed?
Was it stuck in the diff side? I did this swap and had some issues but eventually got it out. I’ll be glad to give advice