Follow on instagram / handy_man_eddie Evan"s youtube cannel: / @justcallmeeddie1 Like and subscribe for more informational videos from Transmissions America.
Things like switches/ ligtb bulbs and associated wiring get loose due to very bad pot holes on the streets. Just to avoid being scammed by auto shops, make sure to check switches wire connections. Carefully disconnect and reconnect them. Carefully because these are quite fragile. Once reconnected, power the vehicle and see if the d light still flashing.
I have noticed that my flashing D will show up when I go into pot holes but I thought I was trippin! Thanks for confirming this, now I know to check the wiring as well 👍
My honda stream automatic drive gear also blinking.. i scan it and same code in your car problem 2nd clutch pressure swithch.,just want to ask if no need to rebuild transmission. Just replace the pressure switch
Hello, I'm having a terrible shifting problem and I'm getting the code p1739 I replaced the 3rd gear sensor switch and I'm still getting the same code and the same shifting problem... Any advice would be appreciated, thank you
I got a 03 pilot i dont have any codes but when i go over a bump at low speeds 20mph it disengages from the gear but will engage again when i come to a full stop it happens sometimes but never on high gear on high speeds
hey just wondering what you’ve got back on this? i have the exact same code, i ended up getting a part but i think it’s for P0847 which is the 3rd switch
I have HONDA ACCORD 2008 MODEL AND ITS GIVE ERROR P0842 AND P0843 .CAN YOU UPLOAD VIDEO OR ANY INFO ABOUT THIS. IT WILL BE HELP 4 ME A LOT TO UNDERSTAND THANKS .❤
Hello my friend, I have a 2020 Honda Civic that has a problem when you start driving at approximately 0.5-1 rpm. It starts to shake a little, and when the rpm rises, the shaking or trembling disappears. Note it has code p0843, transmission fluid pressure sensor/ switch 'A' circuit high Please help me to solve my problem 🌸
My honda crv 1st gen.. when the engine is hot.. d4 blinks and it wont engage anymore.. I have to kill the engine and then re start .. then it runs a bit then des engage again... Already cleaned the solinoids .. replaced atf..
Things like switches/ ligtb bulbs and associated wiring get loose due to very bad pot holes on the streets. Just to avoid being scammed by auto shops, make sure to check switches wire connections. Carefully disconnect and reconnect them. Carefully because these are quite fragile. Once reconnected, power the vehicle and see if the d light still flashing.
I have noticed that my flashing D will show up when I go into pot holes but I thought I was trippin! Thanks for confirming this, now I know to check the wiring as well 👍
Thanks. You make fixing cars easy and understandable.
Thanks for the education, it was very helpful, wish more people would do that.
I am very happy with your clear voice
I can also understand a little English.
Thanking you.
Thank you! 😃
Changed it myself on my honda fit 2007. Thanks for the infos👍
If by any chance you remember, before fixing your car… did your fit have the “D” for Drive in the dashboard blinking?
@@joeghost05 yes
I'm going to change mines today. Do you recommend changing the fluid too
My honda stream automatic drive gear also blinking.. i scan it and same code in your car problem 2nd clutch pressure swithch.,just want to ask if no need to rebuild transmission.
Just replace the pressure switch
My D light just went out~~ no blinking what?? CRV 2004
Very good video. Thanks a million. U just save me some time.
Thanks again. Keep up the good work.
Glad it helped, thank you
Hello, I'm having a terrible shifting problem and I'm getting the code p1739 I replaced the 3rd gear sensor switch and I'm still getting the same code and the same shifting problem... Any advice would be appreciated, thank you
I’m having a P0777 code because my D indicator light is flashing.. Is the the switch I need?
Thanks for the video.
Hello i have a p0845 code should i replace pressure switch for 2nd gear and the 3rd gear?thanks
I suggest that you replace the whole set. Prevent you from having problems in the future
Thank you for the video. They need to be oem or aftermarket is good?
Totally awesome very informative thank you!!
You are so welcome!
I wish UA-cam would allow me to like this video more than once lol. So here in a like and aa sub instead
Trouble codes P2715 solenoid D stuck on..so now where is it and how to test or replace
I have D blinking with VSA light on together! Any ideas? Thanks in advance
Scan for codes.
Thanks for the video. Would like to know if my Honda has 5 gears, then it will have 5 switches?
Most have two or three
I’m replace mine pressure sensor top that drive light stop flashing after at week star flashing again
I got a 03 pilot i dont have any codes but when i go over a bump at low speeds 20mph it disengages from the gear but will engage again when i come to a full stop it happens sometimes but never on high gear on high speeds
Check fluid level
THANK FOR YOU TIME AND EXPLAIN
Could you tell me what is tha part Number For Honda Fit 2013, Transmission Fluid Pressure Switch A 2nd Clutch.
P0843 Code is active in my car.
Do not have part number, try dealer
hey just wondering what you’ve got back on this? i have the exact same code, i ended up getting a part but i think it’s for P0847 which is the 3rd switch
Presure switch A would be?
?
Locations vary depending on model. Have to look it up.
Does anybody know where the 2004 dodge intrepid se transmission fluid pressure sensors located?
Solenoid body on top of valve body
I have HONDA ACCORD 2008 MODEL AND ITS GIVE ERROR P0842 AND P0843 .CAN YOU UPLOAD VIDEO OR ANY INFO ABOUT THIS. IT WILL BE HELP 4 ME A LOT TO UNDERSTAND THANKS .❤
Most likely bad pressure switches
How do you know which one to change ?
Research trouble code and find pressure switch identification for the trans or the vehicle your working on, thx for watching
hi, i have p0842 honda pilot 2011. fluid sensor switch "A" do you have a video for that?
Not at this time. I believe on that model it is in a solenoid pack
Hello my friend, I have a 2020 Honda Civic that has a problem when you start driving at approximately 0.5-1 rpm. It starts to shake a little, and when the rpm rises, the shaking or trembling disappears.
Note it has code p0843, transmission fluid pressure sensor/ switch 'A' circuit high
Please help me to solve my problem 🌸
I'm having that's same problem and code
Possible internal trans slipping clutches of tcc. Check fluid level and condition.
My honda crv 1st gen.. when the engine is hot.. d4 blinks and it wont engage anymore.. I have to kill the engine and then re start .. then it runs a bit then des engage again... Already cleaned the solinoids .. replaced atf..
Scan for codes and diagnose
I have the same problem too, have you resolved the issue already? Please assist
Hellw
@jacobtaylor