M57 Powerd Patrol Build - Part 4 - The Engine {BMW M57 to GU Patrol Conversion}

Поділитися
Вставка
  • Опубліковано 16 вер 2024
  • Finally on the build we getting into the motor - M57

КОМЕНТАРІ • 21

  • @brentmcd12
    @brentmcd12 Рік тому +3

    Go the Patrol ! 🛻🤙📹😎

    • @standinoffroad
      @standinoffroad  Рік тому +2

      She's gona be good when she's done 😁😁😁

  • @alex79buckland
    @alex79buckland 6 місяців тому +1

    Hiya bud just a thought if you were going to change the exhaust manifold why would you not look at doing the twin turbo swap it gives better standard power and torque figures and apparently drives smoother so I been told

    • @standinoffroad
      @standinoffroad  6 місяців тому +1

      I'm not sure if nath even looked into that idea I'll have a chat with him see what his thoughts were.

    • @Nathan_welderup
      @Nathan_welderup 4 місяці тому

      Never considered it but wish I did now

    • @harrywalker968
      @harrywalker968 2 місяці тому

      twin turbo not needed..its not a 79 series..chunk.. i have a ford s/duty. 4.2tdi. 700nm. more than a 79 series. no computer, 1 turbo. its a 4x4, not a race car.. a 6 cyl is better than a v8.. more torque.. per cube.. most ruck engine, marine, are 6 cyl..

    • @alex79buckland
      @alex79buckland 2 місяці тому

      @@harrywalker968 I take it you are not aware of the manufacture doing a single turbo and twin turbo manifold setup the twin is the way alot of people go for a better bhp and torque from the standard tube and once you start tuning it gives very good results

    • @yeetusthyfetus3603
      @yeetusthyfetus3603 Місяць тому

      @@alex79buckland what does reliability look like in a twin turbo VS the standard setup? is it much worse?

  • @HarteshwarG
    @HarteshwarG Рік тому +2

    So if you want an M57 would you need to buy anything else like new diff or transmission and which?

    • @standinoffroad
      @standinoffroad  Рік тому +1

      Not with the patrols that I know of, you need an adapter plate either to the Nissan manual or if you go the bmw x5 auto fusion fab has a really nice adapter to the Nissan transfer case.
      You will need the computer reprogrammed do some wiring and throttle position sensor, there is a bit involved in the conversion but it is doable.
      Nath goes into pretty good detail on the vids.
      Thanks Punjabi 4wd club

  • @bennyjahmin3953
    @bennyjahmin3953 Рік тому +2

    Not sure if you will cover it in a later video but what was the cost on gaskets, etc to freshen up the motor.
    And injectors.

    • @standinoffroad
      @standinoffroad  Рік тому +2

      Hay mate, Nath would be the one with all those details, but I do know he got good prices, but did a lot of looking up all the part numbers too.

    • @Nathan_welderup
      @Nathan_welderup Рік тому +2

      3k injectiors
      438 glow plug module
      500 glow plugs gaskets including rear main. I also replaced idle pulleys 132👍

  • @murphyslawroadside
    @murphyslawroadside Місяць тому +1

    Why not do the head gasket and chain while the motor was out?

    • @Nathan_welderup
      @Nathan_welderup Місяць тому +1

      This motor only had 191,000 K’s I inspected the timing chain and it looked good.
      Timing chains are only recommended on the alloy block as it’s a common failure point.

    • @standinoffroad
      @standinoffroad  Місяць тому

      Thanks Nath 👍🏻

  • @jawdatalrubey6872
    @jawdatalrubey6872 4 місяці тому

    Witch supplier did use source the exhaust manifold from

    • @standinoffroad
      @standinoffroad  4 місяці тому +1

      Hay mate
      Nath said it was this one
      www.ebay.com.au/itm/334330069637

  • @danielgardner6588
    @danielgardner6588 Рік тому +1

    What kays were on the injectors?

    • @Nathan_welderup
      @Nathan_welderup Рік тому +1

      196,000 Ks still ran an drive was a little thirsty failed test leaking, uneven spray pattern and to much fuel bypassing on return line.

    • @danielgardner6588
      @danielgardner6588 Рік тому +1

      @@Nathan_welderup good to know that even at that kms they are best changed out.