EcoTech Vectra Troubleshooting: Red and Green Stall Error/Cleaning
Вставка
- Опубліковано 21 жов 2024
- In this video we will go over troubleshooting tips for the EcoTech Marine Vectra (S2, M2, and L2) when the controller is showing a stall error. The stall error will appear on the controller as a red and green flashing light on the control knob.
This video will go over the following:
-What a red and green flashing indicator means
-What can cause a stall error
-Vectra disassembly
-Proper Vectra cleaning/care
-Vectra Reassembly
-Vectra Bearing; what to look for
-How to install the Vectra bearing if it comes out
-Reassembling the Vectra volute properly
Thank you for watching: Don't Forget to Subscribe!
www.youtube.com...
Please remember that EcoTech does not regularly monitor forums or social media feedback but we are always available and always happy to hear from you. For comments and/or assistance please contact a representative directly at: service@ecotechmarine.com or by calling 1-800-785-0338 Ext. 2. Chat support is also available through support.ecotec... Service hours are 9AM-5PM EST M-F.
My goodness it was difficult finding this video in the middle of trying to find out why my pump wouldn’t run after cleaning.
I think the knowledge base could use a bit of an overhaul for navigation. You should be able to find this without having to specifically state exactly what’s happening in your search terms.
Go to ETM’s website, search for Vectra Manual and the only .PDF you can find is a quick start guide essentially. No troubleshooting, no parts lists, I don’t want to have to search UA-cam for troubleshooting guides i have to watch. I want a manual that shows all of this please. Provide more than videos!
That being said, thank you for this video at least was an absolute life saver.
Purchased this pump about two years ago have only had it running for less than a year (11 months) and it randomly went into stall mode one afternoon. I’ve disassembled it, cleaned it, reset it countless times and still it’s stuck in Stall Mode. It starts then stops then starts and stops again for about 15-20 minutes. I’ve tried a new power supply that I received from Ecotech and have used there App but still the same result. $500 for a pump that didn’t even last a year and now I’m running one with the same GPH purchased on Amazon for $90!!
Very helpful, thank you
do you have some video / manual how to disassemble the main shaft and take out the bearing.
I need to check it if well
How do you remove the bearing?
Didnt work for me… any other solution? Controller is blinking green
What if no lights and not running at all???? Took it apart cleaned everything reassembled pump plug back up and nothing. It just past the two year warranty by a few days . Very frustrating…
Very disappointed in my vectra S2. Began stalling within the 1st week. I was sent a new one and had the same results. Great pump when it works, but expect it to stall at least 3 times per day.
that's my sicce sdc 6.0 experience, vectra fixed it... go figure
How do you prepare the “pre-made cleaning solution”?
You buy some vinegar or citric acid and google the right proportions to mix?
What if the light stays red
Nope. Didn’t work for me.