Drysuit valves, tightening them up without causing damage.
Вставка
- Опубліковано 19 жов 2024
- How to tighten your drysuit valves. This is an easy but important task but can damage your valves if done incorrectly. It also shows how to keep The schrader valve in low pressure suit inflation and BC/wing hoses tight.
Seaskin drysuits www.seaskin.co.uk
Sitech valves advice sitech.se/artic...
Apeks valves apeksdiving.co...
Thank you very much for the video : both complete and clear. Too bad the link to Apeks valves service manual is dead.
I just tape the back of the dump from the inside and with a small glass with a spout pored a rubber glue from the outside into one of the holes on it and let it sit flat long enough so when I picked it up to wear it it wouldn’t leak out.
When changing a shoulder dump, should you use a sealant between the port and the outside valve? If so what type?
Is the inflation valve glued in?
Who came up with the idea of a exhaust valve for dry suits?
Don't buy a suit here I don't answer any inquiries after the money deposit