Wiring a Perko battery switch

Поділитися
Вставка
  • Опубліковано 14 січ 2025

КОМЕНТАРІ • 7

  • @mitch7046
    @mitch7046 9 місяців тому

    Nice video👍Short simple and to the point.

  • @hammett1985
    @hammett1985 2 роки тому +1

    Nicely done love the video thank u

  • @bradharbert8116
    @bradharbert8116 Рік тому +1

    I am in desperate need of some guidance for my pontoon. I have 5 batteries total. I want to make sure they are all hooked up correctly. I have 4 things but possible 5th that’ll require power. I have one Pecko 2 way switch already installed - 1, 2, All and OFF. I also have 2 onboard battery chargers. 1 is 2 bank and 1 is a 3 Bank. I can send pics or specs if needed.
    1. Motor/ignition
    2. Trolling motor 80lb thrust
    3. Garmin Depth Finder
    4. 8 speaker w 2 12” subs stereo
    5. Possible re-hook up bilge pump
    Main ? Is how to hook up all of these appropriately if you can give any advice I would be forever grateful!

  • @tomharvey6354
    @tomharvey6354 5 місяців тому

    Can I use battery jumper cables, just the cables as PO wiring harness

  • @cme4brain11
    @cme4brain11 Рік тому +4

    could have been better explained, so that your explanation matched your drawing. Just connecting the negative posts of the two batteries would produce a common ground.

  • @briancowan830
    @briancowan830 Рік тому

    Why did you put the red line to the black on engine? Drawing😢

  • @tomharvey6354
    @tomharvey6354 5 місяців тому

    I was told you don't use any negative wires. I I almost hooked up negative and the guy said you would've blown the back of the boat off and he says he's seen it done so be very careful when you hook these up.