I put one of these on my water pump today. The original factory switch on the pump was LeFoo. The contacts were wearing out and every once in a while it would get stuck in the on position. Hopefully with the new Square D switch, I won't have any more problems.
This Switch can be used directly on a Water Pipe Line, Right? I was thinking to use a T on a PPRC Water Pipe Line and Tighten it directly over it, Would it Pose any Problem?
Are the 30/50 and the 40/60 switches the same switch but simply adjusted differently at the factory? Or are they physically different switches? Can a 40/60 switch be adjusted down to 30/50?
For the electrical wires - the inside two are from the pump that outside two are from the power - does it matter which goes to which? Do the two on the each need to match something? I can't find out if this matters or how to configure it correctly?
I'm so glad I found this. I forgot to notice the location of wires before disconnecting the white and black wires, thank you
Correction: This product will give you DECADES of trouble free service, it's that good. Thank you for such a high quality product!
Excellent presentation. Confirms I did mine correctly yesterday. Thank you.
Thank you!! My dad wired it wrong and I couldn't find a good reliable picture or vid till now.
I put one of these on my water pump today. The original factory switch on the pump was LeFoo. The contacts were wearing out and every once in a while it would get stuck in the on position.
Hopefully with the new Square D switch, I won't have any more problems.
hi great video., but what i have to do to decrease the pressure switch settings to cutoff=40 cutin20
Helps if you put the tape on in the right direction!
This Switch can be used directly on a Water Pipe Line, Right? I was thinking to use a T on a PPRC Water Pipe Line and Tighten it directly over it, Would it Pose any Problem?
VERY GREAT VIDEO THANK YOU SO MUCH FOR THE DETAIL IT HELPED ME SO MUCH IT WAS EXACTLY RIGHT!
Can it be possible to use in aircompressor I want to change my pressure switch. Thanks
Okay, I have an old 10-5psi switch, is it possible to exchange the
springs and put these on a 60-40psi switch? so I now have a new 10-5psi
switch.
Are the 30/50 and the 40/60 switches the same switch but simply adjusted differently at the factory? Or are they physically different switches? Can a 40/60 switch be adjusted down to 30/50?
I really wanted to be able to see the wires and for some reason on my cell phone it's too dark.
Mine is leaking water from the bottom. Could it be the switch?
Good Job
Hello. Can this switch control a DC pump with AC control power?
For the electrical wires - the inside two are from the pump that outside two are from the power - does it matter which goes to which? Do the two on the each need to match something? I can't find out if this matters or how to configure it correctly?
Have the same problem.. I have the 3 wire plus ground..
I do not know how to connect them the correct way
where do you get the adapter to thread into the plumbing?
All black wires. What planet is that from
Look closer, the two wires on the right are white, the left are black, it's just a darker video
Take down the video if you're not going to show the wire install to the switch; that is part of the INSTALL.
Dude, sure enough it was designed the 1940, it shows...
Spend more time talking about nothing important than explaining the actual procedure of adjustment.
Your teflon tape was installed wrong!