Rotaries, Tumblers, and Settings Thunder Bolt
Вставка
- Опубліковано 28 лип 2024
- We have spent a while running test to figure out settings, and workflows. This is what we found that works for us, maybe it will work for you.
00:00 Intro
06:04 RoKo Twister Tray
07:29 First Tumbler
07:43 First Tumbler Thoughts
10:09 Testing and Settings
18:02 RotoBoss Jr
20:23 RotoBoss Talon
22:00 PiBurn V3/ ROKO Twister Tray
24:56 Final Thoughts
#thunderlaser #thunderbolt #thunderlaserusa #rotoboss #lensdigital #Piburn
Thank you guys for doing this testing, and more importantly sharing your results with the community! I have experimented with the 2.5" lens in the 1.5" holder and loved the clearance it generated, but it seemed to be very finicky about focal distance and my repeatability was not good. I can't wait to incorporate your findings into my own testing. Thanks again!
Always happy to help. Hope it works out for you.
I was having the same issues with my talon and the threads. Jason said to swap to the bigger jaws, and that seemed to work better, but as long as it didnt fall off, I took it as a win. Great Video!!!! Do you use the 4inch lense even with the normal 20oz, have you noticed detail loss inbetween the 1.5 and 4 inch.
Yes we use the 4 inch for everything that way is is less to remember.
@Angrycraftsman Follow up question, are you still using the 25khz, 70ish power 600speed for your full wraps. Im currently running that test on a wrap, from the looks of it right now im not sure its getting though the powder coat. I was typically running 85-87 power 450speed at the stock KHZ.
I wish I could be more help. We reverted back to tumblers in the 35/80. A month or so we had a gentleman show up for a demo and wanted to buy the bolt. He needed a laser quick that could run hat patches.
@@Angrycraftsman no worries, busy same settings before selling? Cup last night cw out good, I noticed a few lines, but I'm assuming that was the rainbow Colors, not Laser fault
@@rykus2010 we kept the same settings may have increased to 90ish power for white cups. There is something with white and the rf tube that just doesn’t work well together
@@Angrycraftsman I'm seeing that, I was running 85 power at 450 and still had a lot of cleaning to do. So I'm hoping the 25hrz helps. Running at 600 speed saves me 10-20 min.
Another question, ever ruin the rainbow with too much power?
@@rykus2010 no the white /rainbow were the hardest to clean. 25kHz helped a lot.
Maybe I missed it, but when are you focusing? Once you get the angle, or before you adjust angle?
We put the cup in and use a digital angle finder to set the angle. It is 3 degrees then auto focus on the far right if the cup where the top ring is. What we may try is a video from start to finish if doing a cup.
@@Angrycraftsman great, I was focusing before angle, then have to lower z to clear tabs. I'm going to move Air assist up and see if that helps me get getter focus. Thank you
@@rykus2010 for us we are using the 4 inch lens. We have maxed out the depth of focus so we can clear the first tab. There is another video for ramp test to determine the depth of focus.
@@Angrycraftsman yea, I don't have a problem at all on the first tab with the standard focus length. Just that middle tab. So moving the Air assist up would clear it without having to lower z. (I think) I'll need to try it
@@Angrycraftsman That would be super helpful!