Charger | How to Fix a Broken Laptop Charger Cord? | Power Supply

How to Fix a Broken Laptop Charger Cord?
To fix the broken power chord, you need not know to solder.
The power chord has a central core and a shield wire.
The shield wire starts breaking first. Afterward, when the wire becomes weaker, it begins sparking and separates.
To begin with, trim both ends of the broken cable neatly.
Then cut back the charger rubber so that you get some wire with which you will be working.
Trim off the outer plastic of the cable using a knife and then slide it off. Avoid cutting the wires underneath it.
Next, peel the wires off the center and twist them.
If by mistake you cut any of the outer wire then cut off the cable and start again.
It is essential to have all the shield wires in connection; otherwise, it won’t charge.
Trim back the white insulation so that the core wires can be joined.
There is quite a small length on the other end of the cable to work with. Try to have the same thing there too.
Match up both ends of the cable and then solder them.
Then wrap some insulation tape on the joint.
Solder the outer shields in a way that the inner and outer wires remain separate while joining.
You can seal up the joint using a flexible glue.
Also, there should be no stray wires that might connect with the core.
Get a silicon electrical tape for the finish of the repair.
#charger #cord #connector

[@AynaeChitral]

Good

[@djkingjalna5216]

nice

[@Widecap]

Good sir
Kindly make a video on
Without souldring

[@Mukul_Adhikary]

No way, in this condition It's not possible without iron.