How to change EVO MK 1 from a belt drive to a gear

To change the EVO MK-1 from a belt drive to a gear drive, follow these steps:
Tools Required:
H2, H2.5, H3, H4 Hex L-Key
T-tool
Motor puller
Gearbox kit
Gearbox grease
Steps:
1. Remove the Rear Wheel*:
Use the T-tool to remove the nuts holding the rear wheels.
2. Remove the Pulleys and Instaoll the Wheel Adapter:
Use an H3 Hex L-Key to remove the motor pulley screws.
Use a motor puller to remove the pulley from the motor shaft.
Install the wheel adapter.
3. Disconnect Motor Wires:
Use an H3 Hex L-Key to unscrew the motor wire clamp and disconnect the motor wires from the controller. Pay attention to the correct orientation of the wires.
4. Remove the Motor Mount:
Use an H4 Hex L-Key to loosen the Caliber Clamp and remove the motor mount and motor from the truck.
5. Install the Gearbox Motor Mount:
Secure the new motor mount for the gear drive using the H3 Hex L-Key.
6. Install the Gearbox:
Install the gearbox onto the truck hanger, aligning it properly.
Attach the gearbox and wheel.
7. Install the Motor in the Gearbox:
Insert the motor into the gearbox motor mount and secure it using the H3 Hex L-Key.
Ensure the motor wire direction.
8. Apply Gearbox Grease:
Add gearbox grease to ensure smooth operation.
9. Install the Wheels:
After connecting everything, reinstall the rear wheels and secure them using the T-tool.
10. Reconnect Motor Wires:
Reconnect the motor wires to the controller and use the wire clamps to secure them.
11. Test the Setup:
Turn on the board and test the new gear drive system to ensure smooth operation.
👉 Subscribe now and turn on notifications to join us on this thrilling journey. Be the first to know as we unveil the future of electric skateboarding.
🔗 Join the conversation with the LINNPOWER community:
Instagram: / linnpowerstore
Facebook: / linnpowerstore
Facebook Group: / linnpower
Official Website: linnpower.com/