Marami Ang brand n pweding magamit sir Kong ma config naman dapat nakaw base ka sa manual Ng sensor na gamit mo Kong 5 or 10 bar ba dependi Yan sa klasi
Sir may inquery po ako. Dpo sya related sa grid synchronizing. Im having trouble synchronizing 2 perkins 4008 series engine. It has a woodward proact model I digital speed control which i connect to dse 8610MKII. from dse wiring topology, i installed 2 interposing for speed raise and lower. It is connected to dse digital output (speed raise/lower relay) on governor side it is connected to terminal 18 and 19. When i tested the unit, i noticed that there is a contact delay on the interposing relay. Do have any suggestion on how to resolve the issue. Can i make use of aux voltage input of governor (terminal 12 &13) and connect to dse internal analogue (terminal 35 & 36). Or do i have to change the governor to model II, so that it can communicate directly to dse.
It is a conventional diesel engine 4008. Based in dse topology, internal relay should be choose. Install two 24Vdc interposing relay to control the speed raise and low
Napakahusay nyo naman idol. Thanks for the share. All done na po here🙂🌻
Wc maam
TAMSAK Done New friend here kaibigan
Hi
Lods gandang gabi.ayis lods
Yes lods
ano ba ang brand ng oil pressure sensor at paano e configure
Marami Ang brand n pweding magamit sir Kong ma config naman dapat nakaw base ka sa manual Ng sensor na gamit mo Kong 5 or 10 bar ba dependi Yan sa klasi
Sir may inquery po ako. Dpo sya related sa grid synchronizing. Im having trouble synchronizing 2 perkins 4008 series engine. It has a woodward proact model I digital speed control which i connect to dse 8610MKII. from dse wiring topology, i installed 2 interposing for speed raise and lower. It is connected to dse digital output (speed raise/lower relay) on governor side it is connected to terminal 18 and 19. When i tested the unit, i noticed that there is a contact delay on the interposing relay. Do have any suggestion on how to resolve the issue. Can i make use of aux voltage input of governor (terminal 12 &13) and connect to dse internal analogue (terminal 35 & 36). Or do i have to change the governor to model II, so that it can communicate directly to dse.
Much good use the analog from dse control going to your engine my i ask this engine using ecu or heinzmann governor?
It is using woodward proact model I digital speed control
It is a conventional diesel engine 4008. Based in dse topology, internal relay should be choose. Install two 24Vdc interposing relay to control the speed raise and low
for deep sea controller
Just use vdo 10 bar