2005 kia sorento no staring💥 fixed!😅

Here we attempted to get this car running .check for spark
We had lots of fuel
Compression was good.
We had what its needed for it to run..but never underestimate catalics.
Cam. And crank sensor was cracked.replaced both.nd new one was faulty .so replaced again

[@jerryfarmer5989]

This is an old vid but I had a problem with our '05 Sorento. It would go into a no crank nothing mode, except dash lights and everything else worked. I replaced the crank and cam sensors, crank code. Then showed system voltage and lean. The bank 2 upstream sensor was out of whack. Plugs were original and worn down big time. Also lean condition it was the vacuum line to the decompression chamber and the vacuum source to the little can by the battery. All good now.

[@ericlester5890]

Dang that has a good starter

[@jackbrown3210]

Good video

[@bugayev]

hola compa, tengo el mismo motor pero en una hyundai terracan, pero viene orientado de distinta manera. Resulta que hace dos dias quería mirarle la correa de distribución, y cuando quité la parte de la tapa y quedó expuesta la correa, había muy poquito aceite chispeado o untado en la parte exterior de la correa, pero muy poco y solo la parte exterior, no la de los dientes, esto por que será? es normal? es grave? muchas gracias

[@c14back2nitrogen9]

Si hay aceite en la correa/banda lo mas cercano a ella pueden ser los sellos de los arboles de leva.

[@mariomunoz1785]

Great video .I'm have same problem on for it not starting. Once I replaced the crankshaft sensor will anything happen if I try to start the car over with out having to put everything back on

[@c14back2nitrogen9]

Did you fix it? Get it running?

[@mariomunoz1785]

@@c14back2nitrogen9 I replaced the crankshaft and camshaft sensors but It still want start over .I Purchase the sensors form Amazon for real cheap. I know autozone has them each for like $125 .I wondering if the sensors are any good.But I replaced the timing belt hydraulic tensioner and set the timing cuz it was lose but still wont start .what do you suggest should do if you don't mind me asking you for sum advice would really appreciate it.

[@whitetiger5181]

@@mariomunoz1785 i have a feeling im goin to have same issue . They told me to replace camshaft sensor . It cranked before i did it. Now that i changed the sensor it wont start. Use to go a mile before stalling. I have the crankshaft sensor ill be installing tom ill let you know what happens

[@gabrieltorres6569]

I will try this

[@Bryan0052]

Hola tengo un problema muy parecido, tengo el mismo vehículo y me ha dañado dos sensores Cranshack en 3 meses, todos genuinos de Kia, y siento el vehículo forzado, sin fuerzas y ningún mecánico a podido dar con el problema. Agradecería tu opinión, o recomendación

[@c14back2nitrogen9]

Dañado en que manera?los quiebra .los quema?

[@Bryan0052]

@@c14back2nitrogen9 los ha quedado, al igual que otras piezas electrónica. El último aparte de quemado tenía un pequeño quiere.

[@c14back2nitrogen9]

Entonces hay que chekar la carga del carro no debe tener mas de 14.5v corriendo.y 12v carro apagado..si los quema pued3 haber mucha carga.cheka los conectores tambien

[@Bryan0052]

@@c14back2nitrogen9 muchas gracias hermano, un abrazo desde Rep. Dominicana

[@roberthfigueroa4055]

Tengo una q no tiene chispa en la bujías ,ya les compré los sensores de sigueñal y leva

[@c14back2nitrogen9]

Ya le manda chispa?

[@fatimahima3712]

Where knock sensor sorento