@@technicalshubham789 I want to add atleast two LED’s as want them to depict if gas value is high or low for eg red led for high gas and green for low gas but when I connect it it doesn’t glow and my other equipment(DC motor,bulb stop working)
It operates on either 12V or 5V , If you have 12v then you can directly give to the Vin pin or Female plug on the board, or if you have 5v supply you can connect to the board or connect 5v to Vin pin on board
how does your bulb glow? my bulb is not glowing (light state is not changing in LCD) if the object is set to moving.. also the G value is "Low" , in your case its "Med".. plzz helpppp!!!
As usual 👌👌👍
LM35 ki jgh ager hm dht 11 use kre to kya hoga or kya hme program me bhi change krna pdega
The code will be change accordingly
@@technicalshubham789 sir mtlb hm lm35 ki jgh code me dht replace kr de to code kam krega
How can I replais the power supply with some thing else because it is so expensive
Yes you can use any power supply like, SMPS of required voltage and current or also u can also use transformers as a power Supply
Hey,how can one add 3 LED's to this? I tried adding them but both the motor and PIR sensor stopped working.
Where you can add the 3 led's
@@technicalshubham789 I want to add atleast two LED’s as want them to depict if gas value is high or low for eg red led for high gas and green for low gas but when I connect it it doesn’t glow and my other equipment(DC motor,bulb stop working)
For that, u should have to change the whole code according to the LEDs levels@@supahuman98
Ye circuit kitne volt pr operate hoga
It operates on either 12V or 5V , If you have 12v then you can directly give to the Vin pin or Female plug on the board, or if you have 5v supply you can connect to the board or connect 5v to Vin pin on board
May I know how many sensors have you used ?
Please provide the code, it's very urgent
Bro can u give the working of this model like the input and output for a project work?
how does your bulb glow? my bulb is not glowing (light state is not changing in LCD) if the object is set to moving.. also the G value is "Low" , in your case its "Med".. plzz helpppp!!!
Please copy my file n chek ur all connections I think ur connection gets mismatch
@@technicalshubham789 okay sir.. Can you please share the circuit diagram of the same?
Thank you
@@tanvigarg8546 www.tinkercad.com/things/aKXDyj9dvp2 open on desktop for better understanding n Tinker these file n run the simulation
@@technicalshubham789 thank you so much sir!!! 💯💯👍🏻👍🏻😌😊
@@tanvigarg8546 Wc
Hey can you share the coding?
docs.google.com/document/d/154KdfMZ6pI0IH6LRQU5H4Pxb-LeDQNIK/edit?usp=sharing&ouid=114617762841863941216&rtpof=true&sd=true
code pls