Bill Acceptor Repair And Cleaning With Washing Method. JCM UBA -Part 1

[@Grimdock]

Us techs remove components and use windowcleaner to spray inside and use the air compressor blower to clean it out.

[@moxie3297]

Obviously these people commenting have no idea about any tech

[@gastonvilar297]

una locura lo de este muchacho, nunca haría eso , 20 años reparando jcm en Uruguay, ni loco
en el mejor de los casos que no te quede humedad, el oxido en 2 meses te lo come

[@murph66able]

Wow, just wow. BV are not made of stainless, so cleaning with water now, then replace the entire unit in 7 months due to rust.

[@educationdonationsdirect4147]

Water on an electric board??!!

[@razecdigrand524]

Mojar las tarjetas y los sensores no se malogran. No se pero tu video no me convence. Lavarlos con agua.

[@angelapadilla2785]

No pasa nada , todo va en secarlos bien con calor yo llevo 14 años reparando circuitos y siempre los lavo con agua y jabón y no hay problema

[@jorgeluisgomezzamata7906]

Yo ya lo hice y queda super limpio

[@igtsasman4539]

oldu olacak legene koyup yikasaydin, olmamis..

[@davidkierzkowski]

I don't think this is a good idea

[@MrKaliwawa]

Don't laugh - remove all electronic components, leave wires and put it to dishwasher. Its the easly way to clean all in short time.

[@ivexXturbo]

Bruh.. wtf are you doing? 😂😂 Just clean it up with some CRC contact cleaner!

[@robertmorrill2697]

my poker machine

[@Hubchopola]

JCM Global
Never seen such Nonsens. Bad methode for cleaning.