JDM Fairlady Z33 GETS A NEW STEERING WHEEL!! + Airbag light fix!

Merch Link BELOW
- Anti Perfect Merch: antiperfect.bigcartel.com
- Anti Perfect Official Instagram: / antiperfectsociety
If you wanna see more content please subscribe to the channel and see new videos on my Evo X Build and what ever else I record and share with you!
Stay Positive, Work Hard, Make It Happen...
#JDMFairladyZ #ZBuild #AntiPerfect

[@permaul2002]

Great job

[@aikonjapan]

Thanks man!

[@shenaniganscat4663]

Fucking dope wheeel!!!! You have no idea how bad I want a jdm 350. Can't wait for the next vid

[@aikonjapan]

Thanks homie!

[@ADDMEONPSN]

Do you know what size resistor for G35 is it 2.2 or 2 ohm

[@NKillmore]

Well done

[@aikonjapan]

Thanks!!

[@aikonjapan]

Feel free to checkout more of our videos!

[@draektears2794]

bro when you soldered the resistor in the connection wire did you do it for both sides or just one?

[@aikonjapan]

Yes both sides 👍

[@draektears2794]

Anti Perfect thank you so much man 🙏🏼

[@aikonjapan]

@@draektears2794 no probs man! Best of luck!

[@Hyphy__Lyfe]

So what exactly did you need to buy for the light to come off??

[@aikonjapan]

If I remember correctly, all ud need is a couple wires, pin connectors, 15 amp fuse and a 2.2ohm resistor to make the circuit.

[@3l1tzx56]

What was the key steps ?

[@aikonjapan]

Here u go!
Step 1
Insert the key into the ignition and turn the key to ON.
Step 2
Notice that the light will stay on and then start blinking. After turning the key to ON, wait until the light turns to off, to start the blinking process, and then switch the key OFF and remove the key.
Step 3
Wait 5 seconds. Stick the key back in the ignition and repeat step 1.
Step 4
Wait 5 seconds and repeat step 1. This should be completed three times. The status light may have a different blinking pattern at this point. Simply follow the same simple steps. Insert the key into the ignition and turn it to ON. Wait until the light turns off to start the blinking process and quickly turn the key to OFF and remove the key. Do this process a total of 2 more times.
When you are complete, you should have inserted the key and removed it for a total of 6 times. Now turn the key and start the car. The status light should stay lit and finally turn off as it normally should. If the light begins to blink again, repeat the steps above.

[@DropAVP]

Y u gotta say actually like that?
(Still love your videos though, no hate)

[@aikonjapan]

Hahaha cause i acktully cant english 😂😂