Daiwa 7HT Mag & ST How To Replace The Main Drive Gear Step By Step Instructions

Поділитися
Вставка
  • Опубліковано 11 гру 2024

КОМЕНТАРІ • 18

  • @zanderman66
    @zanderman66 9 років тому

    Thanks Jamie, this'll also help me with servicing the free spool button on one of my 7HT Mags. I was going to send it back to Daiwa, but think I'll give it a go myself now that you've shone a light onto the art of dismantling & reassembly. I'm still mulling the upgrade to s/s main gear......

  • @dennispenton6872
    @dennispenton6872 4 роки тому

    Nice job. Thanks. I just ordered the pinion sleeve and Carbontax washers for my 7HT MAG ST, and this vid is going to help with the installation of those.

    • @PimpMyReel
      @PimpMyReel  4 роки тому

      Now all you need is the ManFish Stainless Steel main gear!

    • @dennispenton6872
      @dennispenton6872 4 роки тому

      @@PimpMyReel Haha. YES. Soon.

    • @dennispenton6872
      @dennispenton6872 4 роки тому

      On another note. I'm sure that by following your vid that I can swap out the drag washers. Is there a shortcut to doing this? Do you know if swapping to the carbon washers will increase the maximum drag setting?

    • @PimpMyReel
      @PimpMyReel  4 роки тому

      @@dennispenton6872 Why do you think I said you will need to swap out the brass main gear for the steel.... Brass will not take the extra drag you want to add.....!

    • @dennispenton6872
      @dennispenton6872 4 роки тому

      @@PimpMyReel Alright then. Order coming your way...

  • @cliveodriscoll2116
    @cliveodriscoll2116 Рік тому +1

    Thanks for this Jamie, sent you an e-mail

  • @martinpearse267
    @martinpearse267 2 роки тому

    As always clear and concise. Stainless on stainless would have a very high wear rate are they tempered or hardened in some way

    • @PimpMyReel
      @PimpMyReel  2 роки тому

      No nearly as much as stainless steel on Brass....

  • @philmann7081
    @philmann7081 7 років тому

    do you have ceramic hybrid bearings for these reels thank you

  • @brucesr8744
    @brucesr8744 6 років тому

    no grease on the drive gear? ( I don't think its necessary except to quiet the gears.) I notice factory gears are slathered with heavy grease.

    • @PimpMyReel
      @PimpMyReel  6 років тому

      Yep, I use engine grease on gears, just did not want to get any on the table (wife would not be happy).

    • @brianrobinson6017
      @brianrobinson6017 3 роки тому

      @@PimpMyReel I have two of these reels but can not take bearings out to clean them any advice please