Building a Wooden Stand for My NC Tool Round Horn 82 Anvil!!

Hey y'all! I've had my NC Tool anvil sitting around for a while. So I finally decided to build a stand for it!
Here's one of my videos where I review the actual anvil: • Anvil Unboxing! (NC To...
I used a design from Purgatory Ironworks for this build. I linked the video I used below! I watched it probably 20 times before I was done.
Purgatory Ironworks "Building A Simple Anvil Stand": • Building A Simple Anvi...
I have the materiel list for this build below if you're interested in that as well.
2 x 12 (pressure treated)
-7 pieces cut to the correct height for your anvil and stance
1/2in all thread
-4 pieces cut to 12in long
1/2in washer
-8 EA
1/2in nut
-8 EA
**All holes are drilled at 5/8in so there’s a little wiggle room with the 1/2in all thread.
Check out our other pages!
Facebook: / bloodmountainboys
Instagram: / blood_mountain_boys

[@ghostmover3]

Good stuff plumbers metal tape works great to secure it down easy and tight what I use

[@bloodmountainboys9184]

stalking wolf(Custom Knives) Yea thats what I was planning on using! Just haven’t secured it down yet because I move it all the time lol.

[@SquirrelsForAll]

Nice, practical stand. Great job, thanks for sharing.

[@bloodmountainboys9184]

Thank you so much!

[@husafel]

Very good stand! I’m gonna try and make one.

[@bloodmountainboys9184]

Thank you very much! It turned out really solid. Much heavier than I thought it would be lol. Good luck with your build!

[@sonnypena194]

I’ll give it a try,

[@bloodmountainboys9184]

Let me know how it works out!