Good tutorial Sergio. Wish I had something like this back when I was building my cab. Very daunting and confusing if you don’t know what you are doing but fairly easy once you understand it.
I cant get my DOF working with my pinscape. When i set my active low ports to on, my shaker stays on. so do my solenoids when i power the machine on after being off. they just fire repeatedly.
Hi Sergio, it has been a while, sinds i said im going to try to connect the solenoids with the kl-shield. i did it then, but i just couldn't find out witch port from pinscape is the port on my kl-shield. So i feld myself stupid, and didnt want to go further anymore. Sinds a week ago, i looked at the Arnoz older shields, and then i saw it. On the older shields, the ports are written PTE1, like you find it in the pinscape program. But on the kl-shield V5.1 you only see E1, so you have to put PT in your mind for every port on the kl-shield. And then you will know witch ports you need to connect with the pinscape. Hopefuly i helped someone else with this problem. :)
That's fantastic. Thanks Sergio. My shaker motor just arrived so this will be really helpful in getting it hooked up! Cheers!
hola una consulta ise todo lo del video pero no puedo hacer que funcionen los selenoides en conjunto a los botones
Good tutorial Sergio. Wish I had something like this back when I was building my cab. Very daunting and confusing if you don’t know what you are doing but fairly easy once you understand it.
I cant get my DOF working with my pinscape. When i set my active low ports to on, my shaker stays on. so do my solenoids when i power the machine on after being off. they just fire repeatedly.
hello i am a beginner i want to make a virtual pinball if i want to buy pinscape kl25z is it already with the usb cable
Thanks PFG for video on DOF/Pinscape software setup and the link.
Thanks for watching Doug. Hope you found it helpful.
I forgot to tell you that I had to turn up my volume all the way to hear you good.
@@2104doug noted. I'll move the mic a little closer next time
Hi Sergio, it has been a while, sinds i said im going to try to connect the solenoids with the kl-shield.
i did it then, but i just couldn't find out witch port from pinscape is the port on my kl-shield.
So i feld myself stupid, and didnt want to go further anymore.
Sinds a week ago, i looked at the Arnoz older shields, and then i saw it.
On the older shields, the ports are written PTE1, like you find it in the pinscape program.
But on the kl-shield V5.1 you only see E1, so you have to put PT in your mind for every port on the kl-shield.
And then you will know witch ports you need to connect with the pinscape.
Hopefuly i helped someone else with this problem. :)
Thanks for your video, great guide for me
Thanks again, it was very helpful.
My pleasure 🙂
Good vid just supported you
Thank you Garrett. Appreciate the support and you watching it. Glad you found it helpful 🙂