good video.. not expecting an answer --- but if you were doing axle shafts at the same time will they pull out through the open hub without the bearing in place or do you still have to pull the top ball joint nut ?
What did you do in the time between the first few whacks and the last few (when the camera angle and the lighting changes) to get that old hub assembly loose? Mine is not budging.
good video.. not expecting an answer --- but if you were doing axle shafts at the same time will they pull out through the open hub without the bearing in place or do you still have to pull the top ball joint nut ?
thanks for a no jive, straightforward video.
I get to tackle this on Thursday in the driveway....probably during a snowstorm.
Thanks for the vid, I have to do this tomorrow 👍🏼
my 2004 astro has different hubs is yours a 4x4/?
AWD, unless converted. It's the same process, minus dealing with a CV axle for the RWD model. Quite easier
What did you do in the time between the first few whacks and the last few (when the camera angle and the lighting changes) to get that old hub assembly loose?
Mine is not budging.
Probably kept on whacking. An air hammer is handy.
Great, thanks 👍
thank you
Sooooo. You took it apart. What about the replacement and reassembly?
after you remove the surface rust you just put the new one on the same way you took it off