I like this Idea of the tube elements. I've wondered if it would be feasible on 10 meters. Also, what are your thoughts on using non conductive booms and mast? I'll look for part 2.
Hi Justin, I have an old Jaybeam Multibeam MBM28, that uses the quad dipole that it is fed in the centre. I need to repair it, as it corroded apart a few years ago.
Very interesting. i really like the double boom and adjustable side pieces. How much overlap do you use on the "trombone areas" I see that you sell a bender. Is it it difficult to get the length correct on the side pieces with the two 90 degree bends. Any special techniques needed to keep the aluminum tubing from collapsing when you are bending.
The best way is to reduce all elements by 50mm overall to allow for the radius on the corners. Then simply adjust all elements tips by the same amount to finalise frequency. I use between 60mm and 100mm overlap depending on frequency.
hi.. im having trouble with your web site im unable to scroll to the bottom of the antennas section.. i cant see all the options from 432mhz yagis and below.. the old website had no problem,, im on a laptop
Couple of quick questions for you where did you buy the materials do you have part numbers and also do you have specific measurements if someone wanted to duplicate your efforts
Just bought this antenna and I'm exited to get it here and put it up ..got it for 11 meters
I like this Idea of the tube elements. I've wondered if it would be feasible on 10 meters.
Also, what are your thoughts on using non conductive booms and mast?
I'll look for part 2.
I cant seem to find the downloads. Great series of videos.
Hi Justin, I have an old Jaybeam Multibeam MBM28, that uses the quad dipole that it is fed in the centre. I need to repair it, as it corroded apart a few years ago.
One of the most useful videos that I have watched for a while,
Thank you from David in Thailand HS0ZQA
Very interesting. i really like the double boom and adjustable side pieces. How much overlap do you use on the "trombone areas" I see that you sell a bender. Is it it difficult to get the length correct on the side pieces with the two 90 degree bends. Any special techniques needed to keep the aluminum tubing from collapsing when you are bending.
The best way is to reduce all elements by 50mm overall to allow for the radius on the corners. Then simply adjust all elements tips by the same amount to finalise frequency. I use between 60mm and 100mm overlap depending on frequency.
Just found your channel. Well done.
Thanks and welcome
hi.. im having trouble with your web site im unable to scroll to the bottom of the antennas section.. i cant see all the options from 432mhz yagis and below.. the old website had no problem,, im on a laptop
have a go now, hopefully all OK
Yes yes yes
Couple of quick questions for you where did you buy the materials do you have part numbers and also do you have specific measurements if someone wanted to duplicate your efforts
If I was to build a 3 element quad antenna could I use speaker wire, incased in a clear sleeve, or would this not work.
Subscribed. Hope this will help your channel. Wonderful content.