I'm definitely looking at a used vantage pro as a affordable dvom with guided component testing. Hoping you can give a 2023 perspective on the Vantage pro and Verus Edge.
I made a video on this same subject in 2017. I discuss and then demonstrate it on the Vantage Pro and Modis. I also show a simple in cylinder waveform taken with the sensor. Nice job!
Hiya Dave, You mentioned the wiring 1 & 5 for the positive and negative; can you please confirm the pin location for the (green) signal. Thanks in advance
@@davesterl Hiya Dave, Just got the kit (100 & 500psi transducer) and took 35mins to built for my Verus Edge. All working brilliant. Saved a few quid doing it this way. Thanks for video
Gr8 video m8 iv a pro if u have any more hacks or cheap stuff that works with them plz make a video do u know what the cheap amp clamps low and normal are like on the pro
Cheers Dave I have a video on my channel with in cylinder pressure waveform on the vantage ua-cam.com/video/t9xBQNNYlx4/v-deo.html and it worked fine but not as nice as the Pico! The battery as you pointed out on snap on stuff in general is never that great, hope your well cheers sandy
Find the items that are used on the Dave Sterl channel in the Amazon shop.
www.amazon.co.uk/shop/davesterl
I hav a 5000 psi transducer, can i use that one for compression test?
I'm definitely looking at a used vantage pro as a affordable dvom with guided component testing. Hoping you can give a 2023 perspective on the Vantage pro and Verus Edge.
I made a video on this same subject in 2017. I discuss and then demonstrate it on the Vantage Pro and Modis. I also show a simple in cylinder waveform taken with the sensor. Nice job!
Havent seen that myself, I'll check it out, cheers dave
Good info about the 9 pin connector... thanks for sharing! Do the pressure sensors come with connectors & wiring? If not, where did you get those?
Hey Tom, the sensor wiring normally comes with it
@@davesterl Thank you!
Hiya Dave, You mentioned the wiring 1 & 5 for the positive and negative; can you please confirm the pin location for the (green) signal.
Thanks in advance
Signal wire goes to ch1 or ch2
@@davesterl Hiya Dave, Just got the kit (100 & 500psi transducer) and took 35mins to built for my Verus Edge. All working brilliant. Saved a few quid doing it this way. Thanks for video
Hmmm... got me wondering now about the 1st Gen Vantage pin out for the PX Xdcr... very interesting indeed. Thx Dave
Hmmm check the presets on the vantage, then cobble something up if its there
Nice experiment mate 👍👍👍
Hey igor
Wise thinking and useful , keep them coming up mate
Hey Soran, No problem
Cheers again
Forgot to mention Great video
Did you try the 500 in real world tests was it accurate
I used a 300 psi transducer same one as theses made an in reasonable in cylinder wave form
Gr8 video m8 iv a pro if u have any more hacks or cheap stuff that works with them plz make a video do u know what the cheap amp clamps low and normal are like on the pro
No bother Padraig
THANK YOU SIR !
Cheers Dave I have a video on my channel with in cylinder pressure waveform on the vantage ua-cam.com/video/t9xBQNNYlx4/v-deo.html and it worked fine but not as nice as the Pico! The battery as you pointed out on snap on stuff in general is never that great, hope your well cheers sandy
Cheers Big Yin, I'll check that vid out when i get a chance, pretty busy atm