🔴Thanks for watching and if you have liked the Video then you can check out my Master Class on 👉 UDEMY I am highly positive that you would find the Master Class super valuable. Link to Udemy Masterclass : www.udemy.com/course/how-to-read-pids-piping-instrumentation-diagrams-symbols/?couponCode=LOWESTPRICE389 My best wishes for your success, Keep learning and keep growing in your career !!! ✔
Superb information.. thanks...I have questions about thermowell ..how to select stright, tappered,step type and shap size and insertions lenth .any more calculation in thermowell.??? Interviewers akses calculetion of thermowell.
Thanks Asad, what is the software used to do the calculations? I understand a damaged Thermowell can damage equipment downstream as well as, understandably other major issues
Most welcome 😃. Good question !! One of the basis to decide this is the client Design basis. However, in our industry the most widely used thermowell is tapered TWs. Like a similar example is that of thermowell connection, usually we have flanged thermowell but for certain special cases we could go for welded design but this depends on client preference. This is as per best of my current understanding. Hope some engineers can shed more light on to this subject 🙂
🔴Thanks for watching and if you have liked the Video then you can check out my Master Class on 👉 UDEMY
I am highly positive that you would find the Master Class super valuable.
Link to Udemy Masterclass : www.udemy.com/course/how-to-read-pids-piping-instrumentation-diagrams-symbols/?couponCode=LOWESTPRICE389
My best wishes for your success, Keep learning and keep growing in your career !!! ✔
Superb information.. thanks...I have questions about thermowell ..how to select stright, tappered,step type and shap size and insertions lenth .any more calculation in thermowell.??? Interviewers akses calculetion of thermowell.
Hi my Taper ratio is 0.65 is that ok... Because in my past project they are following 32/21
Thanks Asad, what is the software used to do the calculations? I understand a damaged Thermowell can damage equipment downstream as well as, understandably other major issues
Thanks Asad for video.
Can you explain where should we consider straight or tapered thermowell?
Most welcome 😃.
Good question !!
One of the basis to decide this is the client Design basis.
However, in our industry the most widely used thermowell is tapered TWs.
Like a similar example is that of thermowell connection, usually we have flanged thermowell but for certain special cases we could go for welded design but this depends on client preference.
This is as per best of my current understanding.
Hope some engineers can shed more light on to this subject 🙂
Nice Asad..
Thank you so much @Ankur 😊
Hi Sir,
Can u make a video on thermowell calculation?
Yes sure Pratap 😊
Thanks à lot asad
Most welcome ☺️
amazing
Glad to know you found it helpful 😊
This is slightly lengthy
I agree, In current videos have improved on the time duration .
thanks for your kind feedback !!🙂
Thanks
Most welcome 😊