How to make a Push Block (Super Easy and Cheap)

With the help of Steve Ramsey I decided to make a push block out of scrap wood rather than buying one.
Follow along if you’d like to see how you can make one too.
#woodworking #diy #howto

[@chips4289]

I wouldn't use any metal screws in my push block..just use glue... what happens if your saw or router bit goes deep and hits a screw?

[@jimclark6256]

You need to learn what a speed square is and also go to a hardware store and buy a door handle no need for all the cuts. Keep working ,experience comes with practice, good luck.

[@beginnerwoodworker589]

Thanks for the tips!

[@StephenTinius]

1. Where is your riving knife?
2. Where is your riving knife?
3. Where is your riving knife?

[@chbelismail2183]

you should watch more videos about table saw safety .

[@Wildhorse_21]

Dude you need to watch more UA-cam videos to make clean cuts and sand those ruff cuts off. There are a lot of videos on how to make nice push blocks from shop scraps.

[@beginnerwoodworker589]

Thanks for the advice. Still learning and trying to improve with each project, hopefully will keep getting better with time