VOSWITCH JL800 Install- 2020 Jeep Gladiator

Installing the VOSWITCH JL800 on my Jeep Gladiator Overland edition was SUPER EASY!!! Very clear instructions, good quality product, looks good and makes wiring accessories a breeze!

[@figmojustfigmo3820]

FYI: If you don't have a manual transmission, there is a plastic plug in the firewall right where the clutch linkage would be installed for a manual transmission (under left side of dash close to the fender). Pop it out and you'll have a inch and a half sized hole that makes it super simple to route wires from engine bay to cabin area. Just drill/cut appropriate sized hole in the plastic plug, route your wires and reinstall the plug. Done!
No messin' with windshield required.

[@andrews2140]

Looks good. I ran the control harness inside the plastic pirce that houses the main harness. Just cleans it up a little more.

[@vertexairsoft]

Thanks for info just picked one of these up today... Going to use it for my emergency lighting on mine.

[@stiggs4144]

Nice! I really like mine. Hopefully, the video was enough to make your install easy!

[@F.DokHarris-gc2jo]

Great explanation sir. Thank you.

[@drillbittreed10]

The only way this could be any better is by having a link to the product. Great video. fyi you can also run the wire for the controler thu the firewall on the drivers side.

[@stiggs4144]

Thx man! The video was a last minute decision when I went to install it, otherwise I would gone the extra mile producing it…lol. But, I didn’t add a link, because I figured if you found the video you’d probably already found it and searched for an install video as a helper. But yes! You can use the firewall hole to come through as well.

[@destineyleigh2848]

How would you go thru the fire wall!???

[@drillbittreed10]

@@destineyleigh2848 there is a rubber plug in the firewall were other wires are coming thu.

[@Marie-kj3xf]

Windshield won’t budge…I have a sky one touch roof…any advice?

[@stiggs4144]

@@Marie-kj3xf Interesting? 🤔 No, I don't have any knowledge of that specific application. But I know you can feed the control wire through the firewall below and then come up the dash inside the vehicle too.

[@liu23usc]

What are those white clips? Very handy.

[@stiggs4144]

They were just some wire clips I got from NAPA. They had 3M tape on the back to mount them. Cheap and easy and still looked decent

[@liu23usc]

@@stiggs4144 Thanks!!

[@stephenward2908]

Thank you

[@akwardninja42]

You put the stickers over the handle?

[@stiggs4144]

Yep…right on top👍🏻