OSPF Routing Protocol using Cisco Packet Tracer
Вставка
- Опубліковано 25 сер 2024
- This video explains step by step procedure of how to Configure Open shortest path First(OSPF) routing protocol which is internal (Intra-domain) routing protocol using cisco packet tracer
I'm very happy by seeing your vedios of Cisco packet tracer mam because ours lecturers wont explain good like u that u explain . Thanku mam for good preparation for exams
Ssit students attendence -->
thanks!! you saved my life and dignity!!! Love u
Very well explained. Finally understood ospf
Are u Run the network on software ? 😂😂
@@educationsingh2038 I don't know if you were attempting to roast me, but I didn't understand shit cuz my english ain't that bad brother. Do better.
Thank you so much for beautiful exaplannation, it was very helpfull.😃😃😃
this lady is legit, listen to her
Thank you so much...You made it very easy.
Nice explanation... Good introduction to ospf using "Cisco packet tracer".
Bundle of Thanks mam❤
wonderfully explained mam! thankyou!!
Thanks for your effort of helping us
This is a great video,
You are the best madam ❤️❣️🤝🤝🤝
Best explanation
bravo! very good explanation about how to set up a network inside an autonomous system
Excellent MAM. 🌹
Excellent ... well done ...
Superb explanation
thank you professor
thank you very much
Great explanation for the practicals . Just a doubt does ospf really care about the number of routers or the cumulative interface cost
nice
TQSM madam
thank you
hi thank you, should I give static route? ping itt does not reach from pca to pcb only def. gateway.
NICE!!! 👍
Their are ,3 modes in CLI and all this commands doing in 3rd mode , for doing first enter en( enable ) it set u in 2 nd mode after config ( configuration) u enter in 3 rd mode . This ospf protocol command done in 3rd mode of router . Thanks u
thank you maam
THANK YOU
thankyou thankyou thankyouuuuuuu
It’s very lengthy process and I know the shortcut
in router configuration in packet tracer 6.2 I have an error in CLI. It can be solved typing
enable
configure terminal
thank u
Thanks mam
I'll see you in heaven 😂♥️
nice explanation but I could not send from ROUTER2 to PC1 could you explain me plese ?
thank
Please clarify the use of Product Id number and area number and when it change?
Hii mam I have some questions about framerelay eigrp ospfipv6 etc could you explain it please respond
What does area0 mean?
Showing in CLI invalid input detected at '^' marker while writing networks. Why?
in which mode you are
config mode?
enable
configure terminal
ok I put a third pc too
Area0?
You could have used RIP instead of CLI, that would have been easier.
But Thanks for you efforts, you helped us a lot
But then you would not be using OSPF routing protocol but RIP instead.