I'm trying to do the glitch, but right after the series of jumps, I crouch and turn 45 degrees left, but every time I jump forward to finish the glitch, Lara bangs her head against the roof. EDIT: ops, nevermind, got it. Just had to tilt the camera with R3 while doing the jump.
Hi Bob did the trigger ok checked in photo mode and its open when i get there its sealed again. Soon as i leave the crawl tile it closes any ideas im doing NG+
Make sure you're checking in photo mode right after the clip through the wall after the crawl and turn. I clipped through it a few times wrong where the camera shakes left and right. Felt it look a bit different when it was the successful clip shown in this video. Make a save after you've done the standing jump to swan dive then crawl and turn and keep trying to readjust from there. Hope you get it!
You must have slightly got the setup wrong just after 1:46 where we skip the trigger for the Beam at the end. Those jumps etcetera I do are to get past a specific tile which stops the Beam from correctly triggering and allows you to fall down. Would be hard to tell without seeing your inputs but the main thing a lot forget is the standing jump in the setup before the swan dive or not doing the 45 degree turn and just turning slightly instead. Essentially with that whole setup you are trying to slightly clip through the corner to avoid the beam trigger.
Thanks a lot. Readjusted slightly after making a save right after the swan dived the crouch and turn and finally got it. I knew by how that clip through wall triggered and used camera mode each time to check
I'm trying to do the glitch, but right after the series of jumps, I crouch and turn 45 degrees left, but every time I jump forward to finish the glitch, Lara bangs her head against the roof. EDIT: ops, nevermind, got it. Just had to tilt the camera with R3 while doing the jump.
Glad you got it!
Hi Bob did the trigger ok checked in photo mode and its open when i get there its sealed again. Soon as i leave the crawl tile it closes any ideas im doing NG+
Try slightly adjusting after the swan dive a couple others has this help but its basically all about clipping the wall slightly as i do in the video
Make sure you're checking in photo mode right after the clip through the wall after the crawl and turn. I clipped through it a few times wrong where the camera shakes left and right. Felt it look a bit different when it was the successful clip shown in this video. Make a save after you've done the standing jump to swan dive then crawl and turn and keep trying to readjust from there. Hope you get it!
Is this patched with the beam? Seems to have a surface below me trying this or have I done the skip wrong?
You must have slightly got the setup wrong just after 1:46 where we skip the trigger for the Beam at the end. Those jumps etcetera I do are to get past a specific tile which stops the Beam from correctly triggering and allows you to fall down.
Would be hard to tell without seeing your inputs but the main thing a lot forget is the standing jump in the setup before the swan dive or not doing the 45 degree turn and just turning slightly instead. Essentially with that whole setup you are trying to slightly clip through the corner to avoid the beam trigger.
Slightly clip through the corner right after the crouch and turn part?
@@Hartley42 Yeah should just clip the corner and the camera will likely do what mine did in the video :)
Thanks a lot. Readjusted slightly after making a save right after the swan dived the crouch and turn and finally got it. I knew by how that clip through wall triggered and used camera mode each time to check