Thank you so much for great videos. I'm using MasterCam learning edition and having problem with Rigid tapping tapping in verify. in backplot everything is correct but when i use verify it shows Rigid tapping as if its pecking to the final z, instead of one move. any idea why ?
12:50 in mc2021 this used to automatically switch to the active wcs, now in 2024 (we upgraded from 2021 to 2024) it doesnt anymore. Do you know if there is a special setting in mastercam to change this behaviour or could this be a bug/feature?
I have heard rumors that sometime when one feature is turner off/on it could be as simple as the software programmer accidentally deselecting that feature when bundling the new release 😅
This is a great intro video. Very good explanations of everything.
Thanks so much for watching, glad you enjoyed it!
Can You share with us the 2D Drawing of the model you are programming
Thank you so much for great videos. I'm using MasterCam learning edition and having problem with Rigid tapping tapping in verify. in backplot everything is correct but when i use verify it shows Rigid tapping as if its pecking to the final z, instead of one move. any idea why ?
Hmmm, I'm not actually sure on that one. I don't do a lot of rigid tapping on my end. We usually use thread mills in class, but I can look into it!
You may want to check your Simulation Settings. There's an icon next to verify and you can also check in your configuration from the File tab.
12:50 in mc2021 this used to automatically switch to the active wcs, now in 2024 (we upgraded from 2021 to 2024) it doesnt anymore. Do you know if there is a special setting in mastercam to change this behaviour or could this be a bug/feature?
We just deployed MC2024 last week at school. I'm going to be looking into the new changes later this week. I'll keep an eye out for it.
I have heard rumors that sometime when one feature is turner off/on it could be as simple as the software programmer accidentally deselecting that feature when bundling the new release 😅
@@artofthepart lol, i might make a post about it in the mastercam forum
Please keep making videos !
Will do, just posted two more today! Had to take a little break when the semester started.