INFINITY IF18-2 Clutch and Engine Assembly by Jilles Groskamp

[@kyleotoole]

You need to exclude the inner bearing for the first measurement so the clutch bell touches the clutch shoe, from here you can ad the bearing, shims and measure again to set the engagement gap.

[@jessjess3369]

Tuning caster/right height etc video?coming soon?

[@wuchengchung7203]

It's a good video about Clutch installation, Thanks for sharing.

[@thalesnunes3339]

My car broke the second speed gear all the time, do you have some ideia how to solve this problem ?

[@kelbo1805]

Can anyone tell me where can I find the gears for this clutch

[@osos3908]

Nice setup try for explain.

[@nunoalvaroarcas4939]

Do you still mount the pipe on the top deck? Or in the chasis?

[@jillesgroskamp8752]

I usually mount it onto my front bulkheads

[@mattw6842]

Hello, I get revs, but the wheels won't spin any suggestions?

[@TATOLCM]

Nice video. But as I understand, at the end the total gap is 0.7mm. I mean, the gap 0.5mm + the end play 0.2mm, am I right?

[@jillesgroskamp8752]

Yes correct!

[@TATOLCM]

@@jillesgroskamp8752 Ok, Thank you very much Jilles. But isn´t it too much?, considering that you assume (you don´t meassure) the end play, you can finish with even more.

[@jillesgroskamp8752]

@@TATOLCM my end play was about 0.2, it could be 0.3 so total gap could be 0.8. I usually do it like that and all my engine work fine with this clutch setting

[@TATOLCM]

@@jillesgroskamp8752 No dubt about it, thank you very much.

[@59661000]

Hello how can I get hold of this kit