1977 Mattel Las Vegas Pinball - update 4 pulling the mylar
Вставка
- Опубліковано 24 вер 2020
- Follow us on PinballMayhem
Here I work on getting the mylar to lay flat.
If you want to check out the streamed repair sessions on Twitch, head here
/ pinball_mayhem_jeremy
Enjoy - Ігри
I just picked up one of these machines and your videos have been extremely helpful! Thank you 🙏🏻
That's awesome! Glad they are helping you out.
It’s crazy to think that little adhesive and the staples was how that left the factory. Kudos to you for having the patience to continually work on this! I would have lost my patience already😂
I hear you. I took this project on as a challenge - how good could I get it to play? I'm very happy with how it's going so far.
it's crazy to see a full size playfield made from plastic.
For sure! It's only 1/4 thick in most spots. I wish they would have went with 1/2 think instead (sunken in the center) 🤣
That’s different how they work with that metal to metal contact.
For sure! They even patented it.
Jeremy did you think about using spray 90 or even sta-put ? I know a sure thing that would work is optimount but you would have to have that applied at a graphics shop it's like an entire thin layer of tape that once applied to the Mylar it could be shipped back to you than all you would have to do is peel and stick.
That's what's so awesome about this hobby. There is so many ways to do things. For the mylar sheet I wasn't too worried about it sticking down. Just those couple areas that need spot adhesive. Thanks for the suggestion Dave 😎
nice vedio
Thank you sir 😎