Mikuni fuel line route for superjet or waveblaster

[@simpinainteasy680]

Thanks been lookin

[@luissonoma6255]

I don’t much about this, but, I do know that 701’s carry a 38mm carb on all 61x(single carb) and 2 38mm carbs on the 62T(twin carbs) that could be out of a WetJet (44mm carb) 🤷🏿‍♂️

[@erikjolliffe5903]

I have the dual 38mm carbs on my 62T. This is the closest video I have seen to what I have, but since I have the dual carbs, I am confused on the return line back to the tank...

[@surron19]

same did u ever figure it out

[@luissonoma6255]

Thanks!!! I’m like literally in the middle of my project at midnight; I everything is already hooked up but figured I make sure it was placed right. The fuel filter that’s on there is the wrong one and wasn’t sure the positioning on the right one. I’m missing rubber housing so I’ll have to finish up tomorrow. I haven’t started this think in over a year. Any suggestions on how to avoid dry starting? I was think either a tad bit of premix, WD-40, or fogging oil on each cylinder but not sure which method is best. I cleaned gas tank, I’m changing the spark plus and slapped a new battery. The gas cap was left off so no sure if moisture made it into the fuel lines, how can I flush it out before it could enter engine?

[@simpinainteasy680]

Still cant figure how the fuel pump works not mechanical and not electric

[@StreetPulseExclusive]

Will this work on a Wave blaster 2?

[@BuildPlayFix]

@@StreetPulseExclusive yes it’s the same routing.