Recommended Tightening if Anchor Pretensioning Is Not Required Anchors should be brought to a snug, tight condition. This is defined as the tightness that exists after a few impacts from an impact wrench or the full effort of a man using a spud wrench. At this point all surfaces should be in full contact.
الله ينور يا هندسه
تسلم يابو حميد
ممتاز
تسلم حبيبي
تسلم
الله يعطيك العافية بش مهندس
حبيبب تسلم
ياريت دعوة الزملاء للقناة
مهندس شو اسم الكتاب يلي تشرح منها؟
يعطيك العافية مهندس
حبيبي تسلم
يعطيك العافية بشمهندس بس المكافئ ل A490 هو 10.9 حسب ما بعرف اما ال 12.9 مكافئ ل A574 صحيح ؟
Yes
الله ينور
Heat treat alloy steel
1220 Mpa
انتظروا الفيديو القادم مع ازاي نراجع MTC
هل في كود بعيد عن مواصفة أرامكو بيذكر إن تربيط A307 يبقي snug tightening ؟
ال PIP قالت ممكن يتعملها Pretension وممكن لا
علي حسب المشروع ومتطلبات التصميم
Recommended Tightening if Anchor Pretensioning Is Not Required Anchors should be brought to a snug, tight condition. This is defined as the tightness that exists after a few impacts from an impact wrench or the full effort of a man using a spud wrench. At this point all surfaces should be in full contact.
تمام
شكرا يا هندسة
بالتوفيق يا غالي
تابع الفيديوهات الحالية والقادمة ل AWS D1.1