Was always curious about this style of safety hoop, after seeing the install I like it because you don't have to mount it to your floor board but the only thing I don't like is that the hoop itself isn't further supported, and I would be afraid of the hoop itself vibrating or flexing being that is so far away from the mounting position on the trans crossmember. But then again, it all appears to be roughly 1/4 inch thick steel so it is probably fine. Good quick install video
Seen his video and it re-energized my desire to work on my 68. Lately with all the politics and shit happening in the world I have lost my interest in my cars. This video lifted my spirt. Muscle cars are a great positive distraction. Put a new mild build engine, slightly built tranny, and rear end, suspension, fuel system, about 4 years ago and haven’t once go the car running.
nice job thanks for the video , i wonder if you can tell me what's the measurement of driveshaft to the end of the of the transmission ( yoke play) i have problems with my driveshaft needs to be extended turned out it was too short and not engaging enough in the transmission tailshaft ( running a 400 with A833 4 speeds) thanks in advance
Was always curious about this style of safety hoop, after seeing the install I like it because you don't have to mount it to your floor board but the only thing I don't like is that the hoop itself isn't further supported, and I would be afraid of the hoop itself vibrating or flexing being that is so far away from the mounting position on the trans crossmember. But then again, it all appears to be roughly 1/4 inch thick steel so it is probably fine. Good quick install video
Good job! Can't wait to hear it run.
Seen his video and it re-energized my desire to work on my 68. Lately with all the politics and shit happening in the world I have lost my interest in my cars. This video lifted my spirt. Muscle cars are a great positive distraction. Put a new mild build engine, slightly built tranny, and rear end, suspension, fuel system, about 4 years ago and haven’t once go the car running.
nice job thanks for the video , i wonder if you can tell me what's the measurement of driveshaft to the end of the of the transmission ( yoke play) i have problems with my driveshaft needs to be extended turned out it was too short and not engaging enough in the transmission tailshaft ( running a 400 with A833 4 speeds) thanks in advance
Blown classic charger with phat tires on the back "not gonna race it"😂😂😂😂