@@-ms7r- really?! There is am eBay front brake lever master cylinder and the matching side for the clutch was defective and have un matching sides. Maybe the culprit is the master cylinder although not had setbacks with it until now. 🫣😅
@@Kyre5049 If your brakes were working normally before the seal change, it should be the same now. Maybe there is something wrong with the installation. Hope you sort it out soon.
@@-ms7r- how about the pistons when replaced in the caliper were placed flush rather than the orientation they were when pulled out about 1/4 of the way out of the caliper having clamped down on the rotor? 🫣😅
Is there a right way up when putting the new seals in?
@EVil-ob8in
I can't recall exactly. But I think it can go in either way.
Thanks! I needed that. Rebuilding mine now....
All the Best mate!! 😉
hi where did you get the replacement kits?
@@Dominicfearful
In Sg, from Guan Hoe Co Suzuki., Kaki Bukit.
Thanks bro, hope it helps. 😀
Compatibility with CBR 600rr 2010 ?!
@gharbaouiayman7834
Hi, I'm not sure for CBR.
How did you refill the calipers and bleed the lines? My pistons won’t push into the pads onto the rotor. 😮😅
Once everything is installed. I bleed the lines as per normal.
@@-ms7r- really?! There is am eBay front brake lever master cylinder and the matching side for the clutch was defective and have un matching sides. Maybe the culprit is the master cylinder although not had setbacks with it until now. 🫣😅
@@Kyre5049 If your brakes were working normally before the seal change, it should be the same now. Maybe there is something wrong with the installation. Hope you sort it out soon.
@@-ms7r- how about the pistons when replaced in the caliper were placed flush rather than the orientation they were when pulled out about 1/4 of the way out of the caliper having clamped down on the rotor? 🫣😅
@@Kyre5049 That shouldn't be an issue.
Are you just dipping those rubber seals In break fluid? I'm just having a hard time gettin them back in
Correct. Just brake fluid. No issues fitting them in, for me. Maybe they are not seated properly.
@@-ms7r- just ordered a new seal kit gunna try that.. thanks for the upload
@harley187
Thats possibly the reason. I replaced all the seals with new ones. All the best for your project. 👍
Thanks share and nice music.