Greetings! I would like to know, (1) In a speed monitoring system, what system is used for calculating the speed of the detected car, by the inductive loop!? (2) How is the camera activated to capture the license plate of this car, if it is detected at a speed above the allowed speed, on that highway!?
Loops Can Read Speed Of Vehicles As Well as Detection, I Purchased The Red Box Traffic Signal Loop Detector, For my Gas Scooter ,There Work on the Traffic Loops in the Ground, My Version is 175 Khz Trips ,Turn Signals, Straight a Way Loops, Single Loops..
There could be multiple reasons. Is the light green when the loop is plugged in but a car isn't present? You may need to turn up the sensitivity to detect cars. Make sure when you adjust sensitivity you power down and power back up the unit to allow it to calibrate. Make sure there is not a car on the loop when you calibrate. You always want to calibrate when no cars are even near the loop.
I just check now the loop detector both lights Red and Green are ON and its not going turn OFF the light. Pls tell me what can be the prb ? Either the cable is damaged or its the loop detector fault?
Greetings!
I would like to know,
(1) In a speed monitoring system, what system is used for calculating the speed of the detected car, by the inductive loop!?
(2) How is the camera activated to capture the license plate of this car, if it is detected at a speed above the allowed speed, on that highway!?
Loops Can Read Speed Of Vehicles As Well as Detection, I Purchased The Red Box Traffic Signal Loop Detector, For my Gas Scooter ,There Work on the Traffic Loops in the Ground, My Version is 175 Khz Trips ,Turn Signals, Straight a Way Loops, Single Loops..
@@garypinkney5309 Is it possible to use pd232 for detection connected to arduino microcontroller for speed calculation!?
@@gasparo.j.m.7198 Not Sure!! you will have to Research, it a little, A PC may be used Connected to Setup....
@@garypinkney5309 thanks...
We have loop detector in our site, when the car is passing the red light doesn't turning on, pls can you tell me what can be the problem?
There could be multiple reasons. Is the light green when the loop is plugged in but a car isn't present? You may need to turn up the sensitivity to detect cars. Make sure when you adjust sensitivity you power down and power back up the unit to allow it to calibrate. Make sure there is not a car on the loop when you calibrate. You always want to calibrate when no cars are even near the loop.
@@JanosTerroz OK Thanks
I just check now the loop detector both lights Red and Green are ON and its not going turn OFF the light.
Pls tell me what can be the prb ? Either the cable is damaged or its the loop detector fault?
Best