Hell Yea!! We just used our Full Set from them Today... Same Situation. The Flats on the Extractors are terrible. Sutch a good looking set, we were throttled at that. We slotted the Expander to hold it, so you can tighten it up from the top without the Allen fiasco up from the bottom.
I used a 5/8 open box wrench for the thing that goes through the bearing and used a piece of rope through the box end of the wrench and tied it to my bench vise then used a 10 inch adjustable wrench with a 2 foot cheater pipe for the big nut and it worked well with no slippage or wrestling with two wrenches. :-)
They must have updated that large nut sizing...in the kit I just got it is an exact fit for a 26 mm wrench. Still odd that everything is SAE except for that large nut. I didn't have a 26 mm wrench so I just picked a Masterforce one up at Menards for 11 bucks. The flats on my collets are 5/8". Could use a 16 mm also, which is a hair bigger. Thanks for posting.
Thank you most likely Will doing it the same way. I just bought a kit and the directions are so small I can't read them . But I only paid $40.00 for the kit.
Could you not side swipe the center spacer and bash it out from the other side with a drift?. Pitposse do the best spring puller known to mankind. well balanced, good chroming, good strong hook,good welds,good dimensions. If you want to pull, get one.
Quit the jiggling man it's giving me a seizure! ;) Just kidding it was a great video which gave me wrench sizes not shown on my instructions so I wrote them into the instructions.
Hell Yea!! We just used our Full Set from them Today... Same Situation. The Flats on the Extractors are terrible. Sutch a good looking set, we were throttled at that. We slotted the Expander to hold it, so you can tighten it up from the top without the Allen fiasco up from the bottom.
Can you post a picture of what you did?
I used a 5/8 open box wrench for the thing that goes through the bearing and used a piece of rope through the box end of the wrench and tied it to my bench vise then used a 10 inch adjustable wrench with a 2 foot cheater pipe for the big nut and it worked well with no slippage or wrestling with two wrenches. :-)
They must have updated that large nut sizing...in the kit I just got it is an exact fit for a 26 mm wrench. Still odd that everything is SAE except for that large nut. I didn't have a 26 mm wrench so I just picked a Masterforce one up at Menards for 11 bucks. The flats on my collets are 5/8". Could use a 16 mm also, which is a hair bigger. Thanks for posting.
Thank you most likely Will doing it the same way. I just bought a kit and the directions are so small I can't read them . But I only paid $40.00 for the kit.
Where do you get this tool at brother
Same issue here. I returned mine. Went with a different brand, flats are machined correctly. Much better tool than pit posse
Where did you get that tool at?
Could you not side swipe the center spacer and bash it out from the other side with a drift?. Pitposse do the best spring puller known to mankind. well balanced, good chroming, good strong hook,good welds,good dimensions. If you want to pull, get one.
robert harrold what are we cavemen ?
@@RFLIVES We are devo.
Quit the jiggling man it's giving me a seizure! ;) Just kidding it was a great video which gave me wrench sizes not shown on my instructions so I wrote them into the instructions.