Shop Talk : Lets catch up on a few things

Поділитися
Вставка
  • Опубліковано 17 жов 2024

КОМЕНТАРІ • 8

  • @paulwilliams4611
    @paulwilliams4611 10 днів тому +2

    Keep the videos coming, doing a great job

  • @gillian9178
    @gillian9178 День тому

    Yes those out of true running collets can knock out the front motor bearing, also causing excess vibration through out the boat. Had a few of those collets my self out of China.

  • @scaleworksRC
    @scaleworksRC 10 днів тому +2

    Good PSA and shop talk.. I actually just found the same thing after putting the little Cobra back together. It's a wire drive setup, so I think I may have bent the end tightening down 1 grub screw and not snugging the 2 together (my mistake). I don't like the vibration it makes on the bench either, but just have to keep an eye for screws backing out in the future 👍

    • @AdamEverythingRC
      @AdamEverythingRC  10 днів тому +1

      The small things will keep you from reaching full speed. it is the last 5 MPH that is the hardest to get , that is where the little things make all the difference.

    • @scaleworksRC
      @scaleworksRC 10 днів тому

      @@AdamEverythingRC 💯 balance is so overlooked

  • @RDM3DLAB
    @RDM3DLAB 10 днів тому +2

    That is so weird bc I just tried my brand new one from zipp kits and It doesn't fit correctly. Absolute bad quality! I wouldn't have even checked if you did say it. Thanks bud!!

  • @jimstone5339
    @jimstone5339 10 днів тому +2

    In china it's not so critical if collets aren't balanced because they don't go as fast as Americans 😮😅