HOW TO ATTACH A SURFBOARD TRACTION PAD // PRO TIPS with LAKEY PETERSON
Вставка
- Опубліковано 9 лис 2023
- This weeks Pro Tips highlights the main steps in putting a traction pad on a surfboard. Whether or not you've done this before you will hopefully learn a few steps that could help you out.
- Спорт
thank you for your teachings Lakey, it is very nice to put the pad and the stickers on the board, two big hugs from Barcelona because you can see the editor behing three 😂, good health friends 🌹🤙
Hey, hey 7 thanks for all your tips. Have a blast to all wave warriors😉
Thanks, you too!
I always line my tail pads up relative to where the back centre fin box is.
As you want your foot back against the riser on top of your fin.
Also before pealing off to reveal the stick part you line it up and use a pencil to mark the centre back point and top point.
Then outline the bit you want to trim off then place it into position to see if you need to trim more off.
Then go through the process Lakey’s process to stick it on.
This will help not having to use a knife afterwards as you don’t want to cut into your nice new board by accident.
Horses for courses though.
Hope this helps 🤙🏽
I noticed that Lakey doesn't talk about lining the pad up with the fins... She's obviously waaaay better at surfing than most of us, so I wondered if she lines it up subconsciously or if it's just not something pros worry about...
Happy Thanksgiving hope you and Tom have a great holiday season
Same to you! 😊🙌
Good tip. Especially on the over hanging of the rails. Have a new stick coming. It’s a wider diamond tail. Like the peeling a third off first. Thanks 🤙
I've seen some odd traction pad placements here in San Diego. This video should be played live at all public beaches 🤣
Hey Lakey , good job .
You could do a vid for twinny tail pad placement too (if you even have a twinny). A mate of mine bought an Album twinsman and put the block part of the tail pad in line with the back of the fins (I think most people line the tail block up with the back of the back fin in a thruster setup). But we discovered thats not the case with a twinny. Album suggested putting it basically as far back as you can . I'm assuming thats the same for all twins 🤔🤷♂️.
Keep up the good work 👏. 2024 womens world champ 🏆 🙏🏻
Thanks for the tips! What if I want half inch gap near the front and no gap near the kick(like your wider boards)? If I stick the kick part with 100% no gap first, it seems that I have to bend the pad a little to create the gap. The bend could create air bubbles which really bugs me.
Is it the same thing for a twin fin board?
could you fasten m e UP varies at rear neckline
*disclaimer* RIB-TIPS
@4:34 bringing sexy back material 101 #TakeItAllOff
PS!i meadow
Placement of pads has to do with fin placement and u didn’t mention that…
pipe of peace that wasn't a pipeline or tube